开云体育

Just sent them to you. ________________________________ Sent: Sunday, February 07, 2016 2:10 PM To: Crestron@... Subject: [Crestron] Rava built in sound files? Does anybody have the files

Does anybody have the files that are built into a TSW panel for the Rava intercom? I need to use the same ringing sounds to feed into a sound system via an MP3 player.

Inital Setup Menu. Do note that these images are from a AVR 4520CI and will look slightly different but the process is the same. Here is where you set the Network to be "Always ON" Here is where you

All firmware is loaded via the web interface, which, again resides under "Network" i the menu structure. Use the Denon supplied remote control, enter "Setup"...scroll to Network or perhaps Network

How long did it take you?

Hi I am new here, i want SIMPL windows module for Extron AVT 100N. Actually my concern is to get feedback from Extron AVT 100N through Crestron Processor.

In my experience, the older the Denon/Marantz, the flakier IP control is. Most likely, you need to do a hard power restart of the Denon and it will start responding again for a while. IMHO, you're

Well, The Denon is acting up again. Still can ping the unit with the static ip I assigned but it I can no longer telnet or connect through toolbox with the tp/ip client.

Hi group, how long does it normally take to get Crestron Labs access approved?

There was a key digital switcher before and i replaced it with the dm-md8x8.I have video on the displays they are all Samsung TVs but what happens is that the image flickers sometimes and sometimes it

Thanks for the response. No matter what I do I cannot get a web menu (Denon does not offer ffirmware for this model on their website, I fell the web browser is not capable with this model). I was able

Yes. * You may need to reboot the unit's microprocessor? * Have you checked/insured that the unit has the latest firmware? * I have seen cases where units simply act in unusual ways and doing a Micro

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the Crestron group. File : /Modules/SENSORSWITCH nLIGHT.zip Uploaded by : kevinzolitor

sent. I've sent this a few times on request... maybe I should just upload it to the files section. my only hesitation is that it isn't 'finished' and I'm not going to put any more time into it unless

Thanks for the response, I am not able to open the menu via a web browser. The IP address to the unit is 10.x.x.05. I can ping the unit through command prompt. Here is what I am not able to do with

If you know the IP address, simply enter that IP into your browser address bar and it should auto-magically take you the Denon's Menu. I assume you are, indeed, on the exact same Sub-Net and also

I am still having issues connecting to the AVR4806 through ethernet. I can ping the receiver but I cannot telnet into the unit or control it in debugger. Any help will be appreciated

I happen to find nmap. Found the IP

Hi, I would like to use the Ethernet port on the back of my AVR4806 for control. Here is my question... Do I need to set an IP address in the TC/IP client, I am sure that I do :)? If so, does anyone

The last few days I have been getting a connection error when sending a notification to my key. 2 series works fine... Anyone else?