开云体育

Anyone ever control one of these? http://www.veeder.com/us/products/tls-automatic-tank-gauge-systems/atg-tls-consoles/tls-300ci-automatic-tank-gauges

Your MAC Address should look like this "00\x26\x18\xC1\x61\x62" not like this "\x00\x26\x18\xc1\x61\x62" (minus the quotes of course). Your IP address should be "10.1.1.255" in the UDP communications

I am hoping that someone can help with this as I am pulling my hair out trying to configure the module. I have a HTPC on a static ip of 10.1.1.130 on a 255.255.255.0 subnet. The PC is set up for WOL

The girlfriend and I will be visiting Eastern Australia for our 5th anniversary in mid-March (Starting in Sydney, a couple days in Cairns, and finishing in Melbourne after driving the Great Ocean Road

I've never controlled Paradigm from Crestron, but have from AMX, and the protocol is very well documented and pretty simple to use if you want to roll your own module depending on how much you need it

I am about to tap into one of these myself. You find anything in your process that might be helpful? Thanks

We have a huge DMX system with a module for the ETC Mosaic controller including feedback. But it was a custom module written by Michael Block from Block-o-Matic that frequents this group. Try emailing

Does anyone have a module or any experience with the paradigm protocol for ETC lighting? Thanks in advance. J.

I am having the same problem with a DM 16x16 right now. I switched from a 15' USB cable to a 1' AB cable and a 15' USB amplified extender cable and it connected immediately. Doug Guth CTS, DMC-E, BSBE

NM....I found it....error in the S# must have been terminating the s+ thread

Hi there, new to the group and here to learn. I am also new to Crestron programming and have the following hardware: CP2 Processor TPS-6X Touchscreen All relevant software Does anybody have any tips

Running into a weird issue with my serial receive data routine. Device is chatty and I sometimes get two complete response messages in a single logic wave. When this occurs, the second message is not

I did find Answer ID 5060 on their site, but none of those things has helped. It looks like that AID is from 2010 so is rather old, and may not be the same problem as the DMPS3's were not out back

Well, at least I'm not alone, and I guess it's good that I carry around 2 laptops with me, so I can still into the suckers. I just hope my 2nd laptop doesn't start having the issue, or I won't be able

Hi folks, We're trying to directly control a Stingray2 from a CP3, using the CP3 IR out to the Stingray2's 3.5mm IR jack. We spoke to Jack Welsh over at Haivision, who confirmed that it is an IR

I've had the same problem for at least 6 months. Only with DMPS3. I've spoken to Crestron tech support numerous times and they haven't come up with a fix.

I have not. Would definitely like to get it worked out, as I will be on the particular job on Thursday.

Has anyone seen issues connecting to processors with USB before. I get a "USB Device Not Recognized" error from windows when I plug in the cable. Device manager shows an "Unknown Device". I've tried

Were you ever able to find somebody to correct the checksum issue that Sony told you about? Trying to control a 1060 and having issues. Was wondering if you found the solution if you could send me the

The last one released for Denon Electronics AVR-3313CI is what I used for RS232, tried for TCP/IP as explained. I have never tried the Crestron AVR Connected integration due to what I have read here