开云体育

That serial interface might still work.? I would test it before abandoning something that works.? I have one operating on an iAquaLink system, although the Jandy folks say it won’t work . . .

Who understands how the System Key works? I only ask because I've had 24 hours of license fun and a strange thing happened. On an old take-over job, I was on site making a minor programming update and

I just tried a factory reset.? Now I can see it on my advanced IP scan software but not from toolbox.? Looking for the correct USB cable for this.? I must have one someplace.

I'm looking at the Jandy AquaLink 3.1 demo and unzipped the .clz file to see if there is any indication that the SIMPL# source code is available.? But I only saw some DLLs, DAT, manifest, and .config

Tray, the MC3 does not support the authentication needed for a gwexer. You will need to take the firmware back in the gwexer

As Mentioned check for CSAuthen on both ends and you may need to run the unlock / unblock User and IP after setting those. Do not rely on Authen info in tool box just run the command have found that

Try connecting with tool box Secondary Console. Or USB if those don't work and you cant find it with wire shark or angy IP only choice I see is try a factory restore.

I bought 2 PRO3's.? One for the main house for a upgrade from a 2 series.? That one was wiped and had no problems connecting.? The second one still has a project on it. Front panel shows that it

Seems like rolling back firmware to a pre-Auth version might be the answer. I was just stating that I did what you did and it worked on series 4 I know, not much help

This does not work for CEN-GWEXER. Trying to find a solution

I had same issue with a 4 series. Turned out mine was authentication. Just as you describe, I set device username and password, then it worked. Haven’t used a Genwexer since…..

Can't get CEN-GWEX-ER to connect to MC3 control system. setup the user as described and it will not connect at all. Any ideas apart from rolling back the gateway firmware?

From looking at the streaming specifications. The DMPS only supports RTP, RTSP, and SDP streams. Both H.264 and MJPEG are supported.

Any advice on getting a stream on the DMPS3 would be greatly appreciated. I set up a stream with a pull link from Restream (rtmp://live.restream.io/pull/play_3132352_366e659ded2fd19a260d), but could

Hello, We have a Crestron Com-3 talking to a series for Somfy SDB networked shades.? When the shades installer hooked up their PC the shades worked flawlessly, but we can't get consistent reliable

I have a client whose old Polk Audio SR-H2000 finally died.? He had the "lifetime" subscription tied to it so tears were shed.? Is there a rack mount tuner with 232 that is currently available??

Hey CO Cowboy, I dont see that option on any of my outputs. Is that only available on a specific RMC? I am only looking in DM Tools.

The Serena shades are locked to the Caseta platform.

Matt, On the output settings of the endpoint,? there is a selection to play audio without video, but this requires you load a graphics file (we use our company logo). We haven't had any "select video

Hello, Thought I would post this here as well as TB I have a DM-NVX D200 and E30 that I am setting up. I plug them both into a network switch at my desk to configure them and update firmware. I have