开云体育

There are frequent power outages so I want to put a UI message for someone to reboot it and send me an email. There is a dedicated software that runs 24/7 that it might be good to restart after

Are you looking to establish whether the PC (or a specific application on the PC) is responsive, or whether the PC has simply been powered off by the user?? What do you want the behavior to be, if

I need to monitor a Windows PC for its power state so I can throw an offline page on a UI and send an e-mail. I'm assuming I just need to set up a TCP Client for it and watch it's connection status.

Hello, everyone. Intelligent AV is looking to add to our team. We have two posting up on Indeed if you're interested: If you're a Crestron Certified Programmer, please apply using this link: Senior AV

What are you sending the string to?

Does anyone know this programmer, or how to reach him? I'm trying to find the program for an old system that has his name in the comments... Thanks in advance.

Otherwise, if you're looking to do more than just displaying the temperature on a SG button... I'd probably use SIMPL+ to perform ITOA conversions and serial concatenations. Here's an example of

Sounds like you want to use Dynamic Analog Text on a button to display a TSTAT temp value? You would specify something like %3.1f to display a 720d as 72.0.

Hi All, Anyone get reports of an issue with the Back(Prev) button and the VMS4100? My IR code set that works great with the VMS1100 works fine with the 4100 except for the Back button. It generally

*** Serial Concatenation I made one that also adds the delimiter of choice ***

This is the way. Both ports. Separate the AES67 from control. Sonos and control on the same VLAN as the CHome processor.

Take the tstat to the rack and connect locally and see if boots normally with a shorter/different cable. Actually would be easier to just swap another tstat and see if the “new” one boots normally

If you've tested for shorts on the cable, I think your best bet is to find a used unit on ebay...you'll definitely pay the same/more to have it repaired (Not including your time to process

Thanks. I’d agree that the TSTAT cresnet chip has gone. I’ve reterminated the cable twice so I’m sure it’s not the cable. I’ll open a ticket but not sure if the repair cost is worth it given

Steve, I think that would’ve worked for me but that switch doesn’t have the necessary settings like Cisco.

Thank you everyone! I put the NAX on its own VLAN and it was working with Sonos staying online. Noticed in the config of NAX it was originally pointed to the CP4R via the hostname rather than the IP.

Working with an older Leviton A2000 commercial dimming system.? The control board in the dimmer has both DMX and 232 interfaces available, in addition to Lumanet for the Leviton wall stations,

Hey Hadley I'm curious to learn more about how you set up your system to use Mac Terminal to work as a console through the USB RNDIS connection to a 4 series processor.? I'm familiar how to open up

If the Cresnet cable is only landed on the Cresnet connector, and they are properly assigned on both ends, I would say that there is an issue with your cable (nail or mouse chew causing a short) or

Thank you both for the input. Disconnecting the 24v from the Cresnet wire lets the processor boot but the TSTAT is not discoverable then in CH. I have the jumper in the top position and R -> RH, W->