开云体育

If you've tested for shorts on the cable, I think your best bet is to find a used unit on ebay...you'll definitely pay the same/more to have it repaired (Not including your time to process

Thanks. I’d agree that the TSTAT cresnet chip has gone. I’ve reterminated the cable twice so I’m sure it’s not the cable. I’ll open a ticket but not sure if the repair cost is worth it given

Steve, I think that would’ve worked for me but that switch doesn’t have the necessary settings like Cisco.

Thank you everyone! I put the NAX on its own VLAN and it was working with Sonos staying online. Noticed in the config of NAX it was originally pointed to the CP4R via the hostname rather than the IP.

Working with an older Leviton A2000 commercial dimming system.? The control board in the dimmer has both DMX and 232 interfaces available, in addition to Lumanet for the Leviton wall stations,

Hey Hadley I'm curious to learn more about how you set up your system to use Mac Terminal to work as a console through the USB RNDIS connection to a 4 series processor.? I'm familiar how to open up

If the Cresnet cable is only landed on the Cresnet connector, and they are properly assigned on both ends, I would say that there is an issue with your cable (nail or mouse chew causing a short) or

Thank you both for the input. Disconnecting the 24v from the Cresnet wire lets the processor boot but the TSTAT is not discoverable then in CH. I have the jumper in the top position and R -> RH, W->

That depends... If you're powering the TStat with the HVAC system, make sure that you have the 3-position jumper to the top or bottom position depending on whether you're using the RH or RC for the

Hi, please use 3 wires of Cresnet i.e (Y, Z, and Groud) and don't connect the +24V.

Hi All, Having a strange issue with a CHV-TSTAT. ?Every time I connect it to the processor via cresnet, it reboots the processor constantly in 1-2 second intervals. ?Processor just blinks the green

That’s one of the best parts of how Crestron implements the dual ports on the NAX. By default, port 1 is the discovery/control port, and port 2 is the AES67 streaming port. CH will discover it on

In answer to your question, yes we have successfully setup a Crestron Home system with NAX and Sonos on the same network.? While another member of our team set up Crestron Home, I did setup the

I had a similar issue - got around it via separate VLANs and firewall rules to limit the multicast traffic from overwhelming the network. [email protected]> wrote:

Would that not just flood network as well? I should have mentioned, for this site, they are using the Araknis AN210SWR24POE switch.

It's best to use a secondary unmanaged switch for the Sonos. [email protected]> wrote:

Has anyone successfully setup a Crestron Home system with NAX and Sonos on the network? Running into issues, seemingly revolving around multicast, with NAX and Sonos being on the same Network/VLAN.

Hello, is it possible to have a copy of the poly G7500 module you used.....Thanks in advance

I played with Construct for about an hour.? My main takeaway was "time to knock the dust off my HTML/CSS skills" and went down that avenue instead, although Crestron has issues there as well

I love this group!!! BTW, I have already programmed/tested the User interface and that is the only part that I'm not concerned about...(Who knew!!)... Though, As with every updated generation of