开云体育

Use the dimmer module, send the analog value to 0% for off and 100% for on.

I Think The Problem You Are Having Is Like What Someone as Said Below. The RTS Shade Motor Is Kind Of Like A Garage Opener it can Learn Multiple Shades Controls In It Weather It Be A Handheld Remote

Wait till you see the weird behavior with Smart Graphics now when it creates folders for media players then errors you out even if you delete the folders.? Then they magically re-appear!? Yay! --

Well Lincoln!....I would never have made that mistake!!... (he said, crossing his fingers behind his back!...HeeHee...)

Durrrrr.... Blame it on a lack of caffeine... PEBKAC this time around... I apparently had commented out that EQU and just not noticed until 4 seconds after I clicked send. Nothing to see here :) --

Working on an old program - backing out some old logic and putting some new logic in its place. Thought I was done. Program complies cleanly so nothing to worry about (at least as far as loose ends

We've also used the Skaarhoj ATEM link with no issues on a few jobs.? The nice thing is with it, you can use the control software from BMD and the Skaarhoj will tell you what command was sent from

Hello Guys, I'm doing project with Lutron Radio Ra2 integration. Using Modules from the Files section ( Lutron Radio RA2 Modules for Crestron r05 ) Dimmers are working fine, but I can't figure our how

I have had good luck with the?Sony VPL-VW1000ES module (I've used both the serial and IP versions)

Pretty sure it's 9600 on the hdbt serial port.? Having said that, it can be configured for anything you want in the service menu, but outta the box it's 9600.

Sony projectors use 38400 Baud on the 9pin Sub-D, but 19200 9600on the RS232 over HDBT. (Corrected Baud Rate, thanks to Bambam_101) +1 for EVEN as mentioned by Brendon, both on Sub-D and RS232 over

Thanks Tony, the column width was the issue. Resolved! Best regards Crestronfreak55

I also found this when I opened up toolbox on an old virtual machine. If I recall correctly it was something to do with the low resolution setting I had in the virtual machine, I just had to resize

Where you able to get any integration with DSC Neo?? Looking for way to control it. Luis

Thanks, That did the trick.? Everything acquired and working now.

Sony projectors use even parity, it's tripped me up once or twice. -Brendon Brendon Packwood

Check your baud rate.

I have been using IP and CEC to control displays for quite some time. I am now working on a system using RS-232. There are 2 Sony Bravia panels that are working correctly, but I am having issues with

Hi All, sorry for the late update. Unfortunately I had the same issues as described by Sébastien LENOIR: no reliable communication. I ended up adding a Skaarhoj TCP ATEM Link device. This thing is

Give us your Software versions list....