开云体育

Lincoln, Thanks for the reply. The crazy thing is that I’m not getting an error. I’m also utilizing the hangup all calls. It’s like the codec is ignoring all new call commands. The module stays

I believe one retrofit project I did the network design/configuration/commissioning for we had one run (Cat5-pre-E) with a cable run in the “it might have actually been slightly longer than 300

Can’t say I have – though most of my recent Cisco codecs have had the touch 10 as the only dialing control and using a Crestron processor (no TP) as an interface to lighting/shades/HVAC and AV

Hello All, Has anyone seen an issue with an SX80 only allowing you to make one call and then having to reboot it before you can dial/make another call from the Crestron panel? You can still make calls

Thanks Guys! Phil, yes an SG panel and that was what I was looking/hoping for. Formats just as I wanted...? I'm using the (cm) CountDown Timer module. When initially triggers, the analog populates as

I have a samsung frame tv controlled via LAN with its audio out connected to a 6x100.? In the CH setup the TV apps are setup to use the speaker out #5 but the remote still controls TV volume.

I have a run that will be about 275ft.? Shielded CAT6A connected to a 10G extreme switch.? I have a fiber there as well and will be prepared to use it.? But, just wondering if anyone has any

Sorry a little mistake The calculation is the following : Seconds = TotalTime % 60 Minutes = TotalTime / 60 % 60 Hours = TotalTime / 3600 % 3600 Regards, <sebastien.lenoir@...> a écrit

A simple calculation could help you : Seconds = TotalTime % 60 Minutes = TotalTime % 60 Hours = TotalTime / 3600 % 3600 Regards, Le lun. 21 juin 2021 à 21:38, Phil Bridges <gravityhammer@...> a

I can report that this fixed the problem for me. Prior to doing this it would sit at loading interface. After wyatts fix when I hit run as it then asked me for the authentication username and

If this is a SmartGraphics panel? Just format the analog as "time"

Hi All, I'm sure this is obvious, but my brain is a bit soft lately...:) I have an application where I have a 'countdown' analog signal representing time in seconds, where it is hours of time (1 hour

I have not had the occasion to test this. I may have something coming up in the next 1-2 months but it is simple enough that I'm fairly confident in it...

hello, where you able to test this? did it work? TIA

Exactly Lincoln – thanks for clarifying. Cheers, Thorsten Von: [email protected] <[email protected]> Im Auftrag von Lincoln King-Cliby via groups.io Gesendet: Montag, 21. Juni 2021 15:53 An:

I just tried Wyatt's fix but it did not work for me.? When I went to change the setting, it was already checked.? So I unchecked it, tried it, didn't work.? Then went back and re-checked the box,

I believe what Thorsten is saying is that in the existing program they’re currently being used as Ethernet IO devices (along the lines of a QM-RMC in ESlave mode without the processing power) – I

If you aren't even using the HDMI, just leave the DM port disconnected and connect them to the LAN via the LAN port instead.? No need to EISCs to them.? They will just be another Ethernet device

So since updating to the 1.8 FW I'm now getting these errors & restarts once a day as opposed to once every four days before. I'm going to roll back to a much earlier FW when I get home at the end of

I hit the green play triangle, "Run Project As" at the top all the time with mobile projects and it works fine.? If you get a simulator that is blank you have to change the Advanced Attributes in