开云体育

Hello Lincoln, Not hard resetting for any issue related reason, I just want to reduce the runtime so that I do not have 180 days plus of uptime. My main objective is to just have my system uptime

Generally if you’re resetting a processor with any frequency, let alone daily, it’s a symptom of a bigger issue that you should really track down and fix first. I have many processors with a

the scheduler can only kick off one event at a time so if you have 3 events that need to happen at 8:15 it will only do the last one.? Found that out with my thermostats.? had to separate them by a

Hello All, I’m looking for everyone’s opinion on doing a hardware reset on my 3 series processors Automatically everyday at 3am. I was trying to use the event scheduler to perform the Hardware

I'm not in front of it right now, but I'm using it with a PRO3 and it's been working for quite some time in other locations as well.

Thanks for the replies (BB, Jeremy, Steve) BB - tried ... no luck Jeremy - tried ... no luck ... dont want to back load SW as my other programs would suffer... Steve - best advice... i didn't think of

I believed I seen this back years ago in one of my programs.? It turned out to be signal in a module that was named "LOCAL" -- it wasn't even a module that I wrote.? If you do have a signal named

Most common cause is not recompiling the SIMPL program properly. *FW v1.603.0113 requires SIMPL program running must be compiled with DevDB 91 [Jul.2020] or later.* *Also make sure you use Recompile

Hi, any luck with this?

Hi all, Just wanted to ask if some of you have been able to integrate Napco Ibridge and Crestron? I can change the parameter of the Napco ibridge but still with no prevail. thanks in advance.

Hi, Has anyone been able to make the Honeywell 4232BCM version 1.4 module work with the Vista 20p alarm panel and a CP3? I cannot get any communication back from the device (alarm panel) on version

Local is a virtual signal that the compiler reserves (along with 0 and 1), although I don't know how it's used. I would try Project/Resync Project, or go back to an older version of your SMW,

I've actually run into 2 projects where the processor had a current license and had been operating fine.? Upon updating firmware, for whatever reason, the lighting stopped working and reverted back

that's an interesting service. It's good if I can't find any other solution.

Well I was remoting into a site yesterday that Sonos was broken and tried the new firmware and guess what? Still doesnt work. Rebooted Sonos units, rebooted CP3 several times. No favorites had been

Firmware blocking the telnet port is not the problem. You need a Lutron 3rd party lighting license from Crestron. They are free now just have to submit your processor info to them. If you look in your

If Lutron interface is on the same subnet as the Crestron processor and you’re using a device purchased after the licensing change was announced, a license is required for IP control of Lutron if

we are doing integration with lutron QS System using r04 modules First the integration was working well... but after I updated the Pro3 to the latest firmware the connection with lutron processors

Did you use the signal list function at the bottom of the logic tree in simpl?

Hi guys, I have a strange compiler error... "failure - signal label Local" I have searched the whole program for a signal "Local" but cannot find one.? It is listed in the extended signal list. I