开云体育

The sleeve type 3MT to 2MT adapter is to be greatly preferred over the much more common tang type in that at least the Atlas made one does not hang the 2MT widget out in front of the spindle nose.

In most Chinese cases I would agree with you. But how badly depends upon the size and shape of the piston. Most of the Chinese made piston-type tool posts have a very small round piston. The Yuasa,

A Morse #3 solid center or a Morse #2 solid center in a Morse #3 sleeve will fit your headstock spindle equally well. I’d go with the sleeve, though, for several reasons. The #2 centers are cheaper.

I bought a import QC , think it may have been from CDCO , there were complaints about where the handle was when tight , I just took mine apart , which I seem to do with anything new & cleaned it up a

AXA Wedge-type QCTP kit: https://www.ajaxtoolsupply.com/toposet5howe.html?cmp=googleproducts&kw=toposet5howe&gclid=EAIaIQobChMI0_fIzOCo4AIVT1mGCh3dCwJ0EAYYASABEgKaGfD_BwE $129 plus shipping. I am not

Stan, no, I would recommend the wedge type holder. I think I bought mine through eBay. Kurt S. Sent via the Samsung Galaxy S7, an AT&T 4G LTE smartphone

Must be a typo. 175-200 is average online Get Outlook for Android<https://aka.ms/ghei36> ________________________________ Sent: Wednesday, February 6, 2019 9:47:49 PM To: [email protected]

I purchased the Phase II wedge type about 6 years ago. I've been very happy with it. I bought CDCO toolholders and found that their dimensions are a bit variable (the locking handle locks in a variety

Item 68566. Out of stock temporarily Get Outlook for Android<https://aka.ms/ghei36> ________________________________ Sent: Wednesday, February 6, 2019 9:46:06 PM To: [email protected] Subject:

CDCO has an AXA wedge type but they are out of stock and the price is $3,000.

Opps. I forgot the punch line which is: Is this the one you are recommending?

Piston sucks. Get wedge Get Outlook for Android<https://aka.ms/ghei36> ________________________________ Sent: Wednesday, February 6, 2019 9:43:21 PM To: [email protected] Subject: Re:

Kurt, I looked in CDCO, cdcotools.com, but I cannot copy a link to the post and tool holders because the page I am looking at doesn't have a link to it. However, it is item #29461 and includes the

Did you request a replacement part? Sent from my Boost Mobile Phone.

when ya go to buy extra holders , get the #2 & not the plane #1 , the #2 allows square & round tools along with some boring bars . & ya can turn the knurler bout face & use that for a square tool

Short answer is “yes”. A 3MT dead center will work fine in the spindle. Robert Downs Sent: Wednesday, February 6, 2019 14:46 To: [email protected] Subject: [atlas-craftsman IO] Dead Center

OK. That does save time and hassle to remove, rotate and press back on the gear. Robert Downs Sent: Wednesday, February 6, 2019 12:39 To: [email protected] Subject: Re: [atlas-craftsman IO]

Speedoo51: I had considered that the actual threads in the brass were not accurate to the size of the half nuts. Yes, when I was reworking my lathe I replaced my lead screw with less worn acme

Thank you all for responding. This helps a lot. Stan

I concur , best to get rid of as many variables that ya can ??? ??? animal