开云体育

??? ??? Wasn't there one of these runnin around a few years back

??? That seems to have a semi realistic price , looks like there's a steady rest on the shelf under the lathe . Doesn't say what all comes with it . ??? ??? Now is this lathe considered to

Martin, If you have a set of drill bits in 64th increments just try filling a drill into the hex. It should give you a rough idea. A drill bit will be undersized a few thou but if a 15/64 bit doesn't

https://www.facebook.com/marketplace/item/209873378401387/?mibextid=6ojiHh

Any link to the ad?

$1000 on FB Marketplace Craftsman metal lathe comes on stand.Large lathe Craftsman 12” Swing without tool holder 8” Swing with tool holder 36” width Dayton AC motor 1725 RPM 60 Hz 115

A bench grinder will do the job. You'll need a light touch. You're only going to remove 1/64 of an inch off 3 faces, or half that from all 6 faces. For that matter, you could use a silicon carbide

??? ??? The 6x48 belt sander is one of the most used tools in my shop . ??? ??? animal

Any best sander would work, too. Here are some cheap examples from Amazon. You could find them cheaper elsewhere, but Amazon has nice

Amazon lists a set of mini diamond files for $9.39.? The bench grinder will work but you realy got to pay attention and go real slow. Dusty -- This email has been checked for viruses by AVG

Thanks for all your responses. I tried a 6 mm hex key. It does not fit. Tried a 5.5 mm key it's too loose. I'll try a 15/64" next. Unfortunately I do not have the diamond files needed to cut a 1/4"

These are for sale in Tampa area.? Not mine.? Don't know anything about them. Second one says 6" swing but it's clearly

Hello everyone, finally got a shaper.? Been looking for a couple years and they seem scarce around here in SoCal. Missing the usual.? Side door cover, both belt guards and motor. I noticed today

??? ??? Thanks , about the only thing I really don't like about cast iron is machining it , & well trying to weld it is a close 2nd . You have to be in a real good clean up mood before you start

Hi Mike, It's an MLA A-11 cross slide but a little wider than the print because the casting cleaned up well before I was down the the size Andy specified.? I undercut the tail stock side of the table

??? Nice job , is that a MLA crossslide or is one ya made from scratch ? ??? animal

I finally got some idle shop time that allowed me to finish the last bits of the custom dovetail I've been working on for some time. The remaining work entailed cutting a slot all the way around the

I forgot to mention the manufacturer replace the broken tools without asking to see them or have me send them in . They were also very surprised when I told them that I called them cause Grainger

I think the problem with the store I usually go to is they change managers like most clean folks change their underwear . The store I usually go to is in Reno NV . WHen I bought my tool box there I

Take in failed item and show totem and they’ll give you a as good or better free. That’s what they told me. Jim Irwin