开云体育

Dennis I use iTrain with DR5088RC and get solid Railcom detection without any of the shunting which you describe and I use 1k5, or 2k resistors as axle detection for wagons. I have shown a few

Seven months ago I sent an email to Karst about some testing I did on my DR5088RC unit.? Was having the problem with reliable sensor contact. I do use Railcom on my railroad using JMRI. My Railroad

Heath For DR4088LN-CS a 10k resistor should work perfectly. Different systems often require different values and you cannot read across from different systems to get the value for your feedbacks.

I have both the DR4088CS and the YaMoRC equivalent. On the DR4088CS I have added the resistors as recommended. What is the best size resistor to use for wheelsets on N scale? I thought everyone used

Is there any way to increase font size in YD7010 log screen? My eyes are not what they use to be and have a hard time reading the log on screen. Thank you.

A bit more research shows that Loconet B is required for the YD7403 and DR5033 boosters but the YD6016LN-CS/GND can operate on either Loconet T or Loconet B. It's only Loconet throttles or anything

I need some help with connecting up Loconet T and B sockets on the YD7001. I was under the impression that the Loconet B connector was to be used to connect up booster modules and the Loconet T

Novice here.? So programming the decoder with DecoderPro totally completes the job?? I would not need to go through decoder programing in YD7010 or in the Z21 app?? If so, eliminates redundant

Hi John I did that and it was not in there, thanks any way. Just posted it back to dealer.

Did you check your junk folder.? I had a similar problem.? It turned out I got the code several times but it went into the junk folder and I failed to notice.? My bad but it fooled me for a few

I never received the activation code message despite requesting it, that may be the problem !

Reinstall the drivers by right clicking the installer, and selecting ‘Run as Administrator’.

JMRI does do the actual programming, it only provides a pictorial and textual human interface to your command station. The command station - in your case a YD7010 still does the actual programming and

Karst, thank you for the latest manual!? If I purchase, I will be a very basic user.? I have no legacy dcc equipment to consider.? I want walk around locomotive control using wifi and basic DCC?

Glad to see you managed to RTFM. Shorts. These are not "normal". My system runs very well without them...... If you are getting shorts for any reason, then you need to understand why and then take

Hi Iain I did that 4 times with 2 PCs same result, may have been a faulty YD9401. Now given up on it and going back to my old Digitrax.

It sounds very much like you do not have a connection from the PC to the YD7001. I suggest that you re-install the YD7001 software on you PC and make sure you agree to all the drivers being

Also the built in Throttle did not work.

I managed to get the YD7001 after many hours work to get it on but having tried to connect a Z21 WLNA MAUS to the YD1001 it did not work . All settings were correct but no luck, also tried a Digitrax

Hi, it's there, but still only in German: YD7010.Konfig.de ( http://www.yamorc.de/manuals/YD7010.Konfig.de/index.html )