I need some help with connecting up Loconet T and B sockets on the YD7001.
I was under the impression that the Loconet B connector was to be used to connect up booster modules and the Loconet T connector was to be used to connect up all the feedback modules.
?
The DR5033 manual shows Loconet B being used between command station and booster. A separate Loconet T cable is used to connect the command station to the feedback modules. So 2 cable runs needed - a T and a B.
However...
The YD7001E manual shows Loconet B connecting the YD7403 booster and the YD6016LN-CS and presumably GND feedback modules. So only 1 cable run needed. If there are no booster modules then the diagrams show the Loconet T being used.
?
Can I please get a better understanding of whether modules can all daisy chain off the Loconet B connector on the YD7001 or whether I still need to make different runs to the feedback and booster modules. Perhaps things changed from the digikeijs era.
Oldngrey