开云体育

Ian Thanks for the very fast response. Once I have entered the IP address for the Z21 interface, do I need to also enter the 21105 port number into some field in the throttle interface?? If I don't,

The standard networking port for the Z21 protocol is 21105, you also need to put the address of the YD7001 into the multimaus as the Z21 interface Many Thanks Iain Morrison

Hi Now that there is support for multiple throttle connection protocols through the YD7001, I am trying to understand what we need to input into the WLANMaus to get it connected to the port on the

You might want to try the M?rklin protocol instead of the default Fleischmann protocol. That uses another turning-paradigma. Try left and/or right clicking an outlet then. Well... it only "failed"

Just some clarification, the arduino is an Uno and has a motor shield in it and is running dcc++ex. Any ideas how to get s88 support on dcc++ex or how to get it directly on the raspberry pi for jmri

Good evening, in my case the module works correctly, the bridge is positioned in each of the selected positions correctly. What I would like to know is if it is possible for the bridge to go, for

I had a similar problem with using the CML TC1 turntable controller initially and on speaking to the designer the Fleischmann protocol is quite complicated and restrictive.? The protocol expects a

I have an interest in this too. It is a shame this orphaned product failed in the market and I was hoping for a second unit.... In the dim and dark? past, about 2005-7, I was trying to design a

Good morning, attached.

Can you post a screenshout from your "turning" screen ? This one I mean:

Good afternoon, it would be possible to program the DR5052 module so that it goes from one position to another instead of the shortest distance, it does so for the longest distance. I have defined 5

The 4-limit is BBus only ?

Iain I have tried 12V DC with a transformer of 5A but it still doesn't work. Somewhere I have a variable switched transformer capable of 12V to about 18V if I can find it I will give it a try but

Hi All, So do I - works fine. Cheers, Alastair Sent from my mobile device - apologies for any misspelling, misinformation or mistakes

Have you also looked at MTB MP1 motors, I use them surface-mounted in my storage yard (driven by DR4018s) Sent: Saturday, August 26, 2023 6:34 AM To: [email protected] Subject: Re: YaMoRC,

Thanks Andy, I will give these a try and see what happens but I will bear your comments in mind. I did look for an alternative surface mount but didn't see the Rails connect ones, I will take a look

Thanks Iain and Karst, I have preset to 0 but using the DR5000 as power source which doesn't work. I have a 12V 5A power supply in my don't throw it away it might come in useful box so will give it a

I used the PL11 motors in my fiddle yard but they were just too unreliable, it’s not the 4018, I have 3 of them and they all work fine, I ended up swapping the Pl11s for the surface mount motors

My reading of the DR5033 documentation says there is a limit of 4 boosters when using B-Bus but doesn't give a limitation when used on the Loconet B. Maybe I missed it. I really hope it doesn't exist,

Well, they (YD8008) are a.o. specially designed for the PECO motors :) No need to mention that they have been extensively tested with the PL-11's Best results are obtained, by supplying the YD8008