开云体育

Hi Pierre, I haven’t got VARA HF Win Link going yet but have been keeping an eye on it. Putting it on the QDX sounds like fun. I assume that the QDX will only respond appropriately to the VARA FSK

New member in this group, I'm configuring my QRP-Labs QDX with Winlink Express using Vara HF Winlink. There is NO output power from the QDX when I start a transmission with Winlink Express, the

Dave; On the Windows "Sound Control-Panel", on the Playback tab, the 'Default' badge (a green circle with a check mark) indicates that Windows will use the selected device for outputting system

Concerning #1, It could be because the response from the RMS Gateway is sending more data than what the client sends when starting a connection... i.e. an acknowledgment of the first transmission.

On my Windows 11 system, that app is accessed by clicking "More sound settings" from the System > Sound area. ________________________________ Sent: Tuesday, March 4, 2025 1:20 PM To:

________________________________ Sent: Tuesday, March 4, 2025 2:18 PM To: [email protected] <[email protected]> Subject: Re: [VARA-MODEM] VARA FM Winlink no connect - Stumped!

Because the other end is not over-driving their transmitter audio-in and clipping/distorting horribly. And they may be using a "data port" connection instead of a mic jack. 1)? VHF/UHF signal

That's very interesting and informative, and explains why the signal I hear from my transmitter sounds so odd. But, I have two questions: 1. Why does the return connect tone from the RMS node sound so

I swear no one at Microsoft has ever actually used audio controls in Windows - they go out of their way to make accessing them (especially the record / receive] controls) needlessly difficult. You can

*VARA has a far far more complex audio waveform than classic packet. * Classic packet transmits only a single frequency-shifting audio tone at a time.? VARA uses 52 (!) simultaneous close-spaced

My experience is that the volume setting for incoming and outgoing is very finicky. In Windows there are many gotchas. One on the Microphone (output) there is voice enhancement, I found it in Windows

Well, I had just done a Winlink session and had not changed any settings when I tried again. When I subsequently tried the packet session, I made no changes in my sound settings. I appreciate your

I have used both squelched and unsquelched with the radio, no difference. The RMS never responds to my connect attempts, so there is nothing to receive. I'll know more when new sound card interface

Check the "Playback" settings on your Windows "Sound Control Panel"... since you're using a different app for audio I/O (Direwolf vs VARA FM), your sound settings on the control panel might be

I second that... However we're talking about receive volume here. If you're monitoring the channel with a second radio (HT), and the gateway station isn't responding to an "Auto Tune" test, the

audio levels are very tricky on VARA FM.? Using an HT, it's easy to hit the volume knob (there's no "data" port on most HT's).? I'd try turning the volume knob down and retry the autolevel

Thanks for the reply! with the 2980 and my licensed versions of VARA I’m seeing excellent speed and good throughput, also so far with my testing of the targus hub I’m seeing no discernible

Hi Matt (and others), I did have setup a Hybride RMS but it is off-air because of local regulations but if needed I can switch on. It has VHF with Packet and VARA-FM (Wide) , UHF with Packet and

Thanks for the replies everyone! My issue was very simple and I should have checked first. When I connected both radios into my USB hub the PC changed the names of the Soundcard interfaces due to the

Sorry, that was a typo! I have tried high and low power, with no benefit. At this point, I have another sound card coming in later this week, and I'll see if that makes any difference. I did try