开云体育

Sorry, that was a typo! I have tried high and low power, with no benefit. At this point, I have another sound card coming in later this week, and I'll see if that makes any difference. I did try

Dave; I looked up all three gateway stations on Winlink.org ( http://Winlink.org ). It looks like NV7LV-10 is a typo on your part... the closest call I could see on the WInlink.org (

W7DEM-10 (4 miles away);NV7LV-10 (18 miles away); KL7RI-10 (23 miles away. I have successfully connected to all three in the past, the one at 23 miles was a bit sketchy! All use 145.610 for their

Yes to all your questions. Also, I can hear one of the nodes (not sure which one, as the frequency is shared with several in the area) make a connection to another station, and the connecting

What are the call-signs (and -nn extension) for those three gateway stations? I'd be very surprised to see three VARA FM Winlink RMS gateway stations in close proximity all being on the same

Do you hear all 10 Auto Tune bursts, at increasing volume levels? Watch the Auto Tune counter... if any bursts are missing, are they at the beginning or the end of the sequence? Are you selecting the

I assume the G90 is for the HF side. I don't have HF yet but I will. My current set up: - I am using a BeeLink Mini PC running Windows 11 Pro. - I am using two Digirig Mobile and two Yaesu

I didn't mention Vara FM, depending on what sound card. I know the digirig will need a comport to PTT the VHF radio. 73 *Don PoapsNew Westminster, BC*VA7DGP DATA VA7QU VOICE *Winlink:

I'm not sure what your getting. I see 2 soundcards. I know what the G90 does and I have used my digirig with. I have no idea what the FT 2980 does. I have a Motorola radio using a (VHF) 9612 Kantonic

Also, I forgot to mention - the initial successful connection was with a rubber duck on the HT, after that I switched to a gain antenna on the roof. I also tried going back to the rubber duck, but

I always select VARA FM Winlink for my sessions. Also, the gateway is just 7 miles from my QTH, and I have no problem connecting with a packet node (2m) that is 20+ miles away. I literally had just

The message in the outbox won't affect the connection, but selecting VARA FM P2P vs VARA FM Winlink will. Dave I've been able to use an HT to connect to Winlink gateways that were either really close

Yes, I'll check, but I never have used P2P, so I'd be surprised if that was the case. [email protected]> wrote:

Another guess. Is the message in your outbox set as Winlink, instead of P2P? If set to P2P, then unless you are connecting to a node that is in P2P listening mode and also is the callsign your

Mine connected to Radiomail by selecting the VR-N76 in Radiomail itself. Same with aprs.fi. It doesn't seem to connect via the BT page in settings for those, but I have tried with multiple iPhones and

Hello Mark, Yes, I tried autotune and ping - no response. The last time something like this happened, I found it was because I was selecting VARA FM Radio only. Once I selected VARA FM Winlink,

Have you tried running an "Auto Tune", from the VARA FM "Settings -> SoundCard..." window? On your 'monitor' radio, you should hear all 10 signal bursts at increasing audio levels. Many radios stop

Has anybody gotten their hybrid RMS gateway successfully configured? I’m running relay, packet and trimode but I don’t want to tie up my 705. I’m using a g90 and ft-2980, is it possible to put

FWIW, I have tried a range of TX drive levels, but still no joy. Since the hardware works with my packet setup, I have to think it is something in RMS Express or the VARA-FM setup, but I changed

I had finally figured out how to use Winlink with VARA-FM and an AIOC into both a Baofeng and an Anytone 878. I also use the same hardware configuration for Direwolf/Outpost packet BBS