开云体育

ok, yeah, fair enough.? thanks, Cliff K6CLS CM87

Just an FYIIf you use the EXPORT command instead of DISPLAY the output does not have the "is" between variable and value.This can save the buffer to a text file and then be sent back to the TT4 to

Rob Thank You! You helped my out again! I didn't realize those things you highlighted, all have been fixed.? Now I'll stay away from the copy and paste commands and all should be good! Thanks and 73

Maybe so, BUT ... We are not talking a few notes from touch-tone (which someone could argue is dialing), we are talking about a "tune" that gets repeated over and over until the "fox" is found. Is

Oh come on, folks .. Noone ever used a DTMF phone patch? No one ever played "Mary Had A Little Lamb" with a touch tone phone? I don't think fire and lightning will come down for a short little ditty

Is that guy in Canada still illegally broadcasting music on the Ham bands?? When I started out near 20 years ago he'd be right in the middle of the phone section of 20 meters.? Hams griped about it

Same under UK Ofcom regulations, indeed probably most authorities: “A radiocommunication service for the purpose of self-training, intercommunication and technical investigations carried out by

Wouldn't that be considered "broadcasting music"?FCC 97.113(c) (U.S.A.) : states "No amateur station shall transmit Music using a phone emission except as specifically provided elsewhere in this

Brad, Great idea! We have a group in the Austin, Tx area using Byonics products. We hunt from Friday evening to Sunday evening sometimes with two foxes. A variation in tunes would add a bit of spice

Hello all, This this is listed as all Byonics Products, For some of the creative people in mind, Why not list some of the alternative tunes you use in your transmitters? A couple that I threw

I saw the note where you commented on the SQL appears to have fixed your issue.This CDMODE TONES mean you should have the SQL open Here are a few comments on the settings you asked about: ????

I was messing with the squelch and volume controls and suddenly it started digipeating... So its working now, but I'm not sure why lol!

Hello all, I previously had my TT4 working perfectly (just yesterday) went in to the programming software and accidentally hit Control V instead of Control C, and it messed up nearly every value I had

I did that and they are. Does that help? I think we might be getting in my head with resistors and the like. KB3KBR Greg. Sent from my Samsung Galaxy smartphone.

Before buying, take a closer look at my explanation (sorry I didn't draw a wiring diagram).I was going to use the photo and show wiring with it, but the photos leave out the 'control' side of the

If you use power relay contacts rated at 10A to switch a pullup or pulldown to create a logic level, you might have unreliable/intermittent switching. You don't want to be switching a weak 100K logic

I might just get that board and replace the other one. Just to make life easier. KB3KBR Greg. Sent from my Samsung Galaxy smartphone.

Ok so I've taken a look at that. Seems like there a quite a few connections on that, how would it be wired up? KB3KBR Greg. Sent from my Samsung Galaxy smartphone.

It would be a LOT easier to just add a relay "Normally Closed" (N/C)12V to the "MAIN" . Connect 12V to coil and Ground from the MAIN input - always energized as open.? Ground to common input and

One quick check you can do with a VOM (Volt, Ohm Meter) would be continuity between the 3 "N-" connections (N1-, n2-, and n-).I suspect they are all connected together. Robert Giuliano KB8RCO