开云体育

Steve: Found it. When a file loaded, it was running the macro thread in the backround without waiting for the previous one to finish. If a second was started while the first was running, an error

Bob: Good point. In lathe, you never really know which axis needs to move first as a safety move. Depends on if your doing inside or outside work. There is no safety on the next version of Turn. If

Isak: This is probably because you have Constant Velocity turned on. When you run with backlash, CV is not possible on all systems. Usually, you have to turn it off, then the acceleration and

The safe move on a turning machine is the Z axis, same as a milling machine. You move the carriage away from the chuck axially(+Z). If you moved the X axis with a drill buried in the work piece, you'd

It has to do with the const velocity/exact stop. Thanks, Isak.

Hi, When I enable backlash the steppers sometimes stalls. The problem arises when a continous move is made on one axis (suppose X) and in the middle of the move the Y axis changes direction. This

Steve: I've only been able to see it twice. It locked me up for 5 minutes the first time, and then 100 boxes appeared saying "Parse error". This tells me that somehting is looping and calling the

Thanks Art - The more I think about it the better Safe_X sounds, done the same as mill as a persistent entry box would give you the chance of setting the distance or having it turned off, as

This condition does not normally occur in a properly tuned OK, it's like I supposed. No problem with this. Mariss @ gecko is an excellent vendor and supports the since I already had a deal with Mariss

Does the LED stay on with the Printer cable disconnected from the PC? If so there may be a problem on the card. If not then do you have the proper step pin mapped and IS IT ACTIVE LOW (checked).

loop The servo feedback loop (from the encoders) is done in the Gecko or Rutex. MACH2 does not know if the motors got to where they were supposed to...only the GECKO knows. If for some reason the

Hi John: Goto Z's, is to make all axis goto zero. Goto Safe_z makes the Z axis move to the clearance plane (Safe_Z). This will be renamed to clearance Plane in the near future so that in Turn, it will

Hi Bob: I don't know whats going on with the LED always on on the board, but don't expect to see the step LED's blink. They are blinking, but only 1-10 us long in the on condition. This is too short

Some bd with a torch bringing more work. John S.

What are the buttons "Goto Z's CTRL O" and "Goto Safe Z" supposed to do and how do you configure them? I am working on a set of 640x480 screens to use with my Sherline 5400 mill and at that

PREAMBLE I did a lot of research and the Mach2/Sound Logic (purchased from Campbell Designs) looks like the perfect setup for my application - a plasma table. The Sound Logic board arrived just a

Sod's law said this would happen, but I've just done a largish engraving file for mill and tried it - got two parse errors first time, (it has two tool changes, maybe coincidence) then ok on

Steve: Your right of cource, the concept of a Safe_Z is geat with mill, but in lathe it should be safe_x. I will be redoing those sections. Thanks fopr the test. I don't know why the macro's are

Hi, I'm going offline for a month. I'm off to Italy and the Czech Republic to race my bicycle in the IPC European Championships. As such I won't be able to answer any questions or process any order

Art I don't know if you just forgot or have been to busy but r11 still has the following problem.When tripping the softlimits the error line shows this but, when you jog off the limit the error still