开云体育

Thanks Art, it does work, but as you suspected still needs a few tweaks. I have posted a picture so as to show you what I mean. http://machsupport.com/forum/index.php?topic=183

Here http://machsupport.com/forum/index.php?topic=184

Thanks Art, I have added some more notes and another sample to hopfully inspire the requested changes. http://machsupport.com/forum/index.php?topic=183.0 If this all gets too hard, then drop it. I am

Aaron, many of these screens are concepts waiting to be made after the requested changes are made. http://machsupport.com/Coppermine/thumbnails.php?album=topn&cat=10001 I have only really made one

I recently purchased a breakout board from Bob Campbell. Service was great and it seems to be a quality board. However, I tried downloading the SoundLogic.xml file (to get the pinout config) but the

Hi Guys I'm a newbie to the group, and Mach 3. I have recently purchased an AVON 2200 CNC vertical mill with faulty Anilam Crusader M series controller. Have fixed much of it, but it's not

Thanks Chris I though the servo drives were some form of +/- analogue input. If the servo's are +/- 10 V it won't be difficult to switch the direction and pulse signals to drive these. However they

Thomas, I like to use one limit sensor on each end of travel for my X and Y axis. This is mostly for safety reasons. On my Y axis, I ended up placing two targets and one sensor. Mach2 knows the

George, One parallel port can handle four axis. On our breakout board on each limit axis we have two sets of screw terminals. One is labeled home and the other is labeled limits. The screw terminal

George, On our breakout board we use pin 10 for the ESTOP. Bob Campbell Bob@... www.campbelldesigns.com Breakout board THC board sets CNC router plans Stepper Motors

Thomas, I use one limit sensor on my Z axis, two on my X axis and one on my Y axis with two targets. Bob Campbell Bob@... www.campbelldesigns.com Breakout board THC board sets CNC

Matthew, I am not sure of the correct answer, but for soft limits on any system to work, I would expect that you would need to home your machine to set a reference point. You would need to start with

Thomas, I use the same sensor for home and limit. On my CNC router, I very seldom home my machine. I just position the router to where I want my 0,0,0 point to be and do a G92 type command. The

Peter, I have used Adobe Streamline in the past. It worked very well. I have also done a manual trace with Rhino. Corel Has a program called Corel Trace. Bob

Please all keep in mind that this forum might go away if Art is not intrested in the move. The reason for this new group is to move the Mach1-Mach2 issues here so we can perserve the older messages

Art, Steve Blackmore discovered that RC7 has no PWM signal out put. I have checked my development PC which I have RC7 installed in and it appears as though RC7 is not capturing the parallel port/s.

Hi I have put the latest manual PDF into Files over here and will delete the Master5 one when a few people have come over. I will also change the reference in the documentation to point people

Test Andy

I am researching CAM programs like VisualCAM, BobCADCAM, DolphinCAM, Rams3D. I would appreciate any feed back on these or any other CAM program. Basic drawing, stable tool path creation and post

I would suggest you also consider TurboCADCAM. The 3D CAD is outstanding in ease of use and functionality. One of the best features is the wide range of file reads. It can read in from just about