On Fri, 22 Aug 2003 11:21:26 -0000, you wrote:
Your right of cource, the concept of a Safe_Z is geat with mill,
but in lathe it should be safe_x. I will be redoing those sections.
Thanks fopr the test. I don't know why the macro's are affected
only in Lathe, but will check. There is a light somewhere up ahead.
Sod's law said this would happen, but I've just done a largish
engraving file for mill and tried it - got two parse errors first
time, (it has two tool changes, maybe coincidence) then ok on
subsequent tries even after a reboot?
It didn't crash OCX.
Tried on 3 PC's of varying performance and it does it on all.
Only seems to have happened since changes in RC10?
ie
5) Macro's changed to multi-threading design. They now run in parallel
to the engine.
6) New Macro Commands:
IsMoving Returns a 1 if the interpreter is processing movement.
GetPortByte( address ) returns the byte at that port address
PutPortByte( address, byte ) puts the byte into that port.
--
Steve Blackmore
