开云体育

why does it matter if it flexes a little? Jack w4grj

I am installing the ATAS-120a on a Hummer H3. ?It seems that no matter where I install the Diamond K-400 the Metal on the Body Flexes. The Body Flex Movement in the Antenna in the amount of 1 - 2

The MX62M passes dc.?Ron Jakubowski, K2RJ?Sent from my Galaxy Tab? S5e

The other thing you need to be certain of is that there is a DC path through the diplexer from the HF port to the antenna port so that the ATAS antenna can be controlled from the radio. 73….Eric

Don't apply voltage to the brown wire, it might not end well. Page 32 of the user's manual specifies connecting it to ground. Randy (KE5EOT, WRJS252) ARRL, QCWA, ARES, RACES, ROWH

Thanks for the reply. -- WB5YDA L.B. Little President Beaumont Amateur Radio Club

If connected to the 13.8 volt supply it puts the radio into low power mode, If I remember correctly 20 watts.

If you ground the brown wire that maximum power output is reduced to 20 watts. It was first used in the 897. When the battery was installed, the power was reduced to 20 watts to lengthen battery life.

Can you tell me what the brown wire is for in the connector?

This is the plug that is on the power pigtail. It is called a HF 6 plug. The side that is chassis mounted is quite often the real problem as they wear are jerked around and not replaced. Here is a

You have to make sure the locking mechanism inside the powerpoles is engaged. Sometimes it takes a little extra push to get that "click" that ensures that the connector is all the way in. Once it's

I made a 3 pin Power Pole, red, black and brown, then made a power pole jumper that with the brown wire shorted that could be thrown in the middle if I wanted to used it that way.? ?When I got the

Perfect, ordered Antenna and plexer! Going to be alot of fun cycling and doing HF!

I did just that. I used #12 wire and found it sufficient. Just about everything I have around here that runs off 12 volts DC uses 30A Powerpoles. 73, Zack W9SZ wrote:

Yes, the MX62M is the one you want for the 857D.? I am using one with my ATAS and it works fine.? The main difference between models is which port 6M is on.? On the 857, it is on the HF port, which

My trike, which currently has an FT-8900R and CR8900 diamond antenna.

I posted the original and I am trying to put my 857 on my trike with an ATAS 120. Maybe I am looking at the wrong item. I need one of them to link both outputs from the radio to the single ATAS

Don ... Be sure you know the difference between a duplexer and a diplexer. They are not the same and often confused. What, exactly, are you wanting to accomplish? 73, Kent K9ZTV

--Hello; I would like more information about the MX62M duplexer.? Can the mx62m duplexr tune on the Yaesu FT857 and ATAS-120A.? ?I Have sent an email to Diamond requesting information.? ?I am

At that point, I'd replace the pigtail with Powerpoles. I use silicone jacket wire from the hobby shop, either 10 AWG or 12 AWG, in red & black. The contacts are Metric, standard Molex connectors are