开云体育

No change. I also tried ls -l /dev/tty* to shorten the output. I tried both unplugging and plugging the cable as well as powering the rig down and up.

I've been trying ls -al /dev/ and I get a ton of output. I didn't notice anything new from try to try but will use your string and try again. Thanks.

And if you don't see it there, unplug the USB to the radio, do ls -l /dev then plug the USB into the radio and turn it on and run the same command again. Look through the list to see what changed.

I know it's not YAAC at the moment. I'm communicating with Argent Data to sort out why their device might not be recognized. Data mode is activated on the Alinco. I've tried changing cables,

Just to make sure it's not a YAAC problem, after connecting the USB cable and powering up the Alinco radio, try issuing the Linux shell command: ls -l /dev/ttyUSB* Do you actually find any such

I'm using ls -al /dev/ to see what's recognized. Lots of tty entries but no ttyUSB0 or similar. I'm communicating with Argent Data to see what I need to do ... Thanks

You still need to tell YAAC what type of equipment you are connecting (a TNC, a GPS receiver, etc.) first, i.e., the YAAC Port Type. Then YAAC will give you a list of physical connection ports

Restarted YAAC last week to restore sound alerts. Been receiving messages almost daily and APRSThursday messages today, all with sound alert. So far so good. I'm hoping it was just a transient

They provide a short adapter cable from the mini-USB connector on the TNC board to a printer-type 'square' USB-B connector. I tried bypassing that adapter with a mini-USB to USB cable, to rule-out

How is the Argent product wired through the radio case?

I'm used to seeing /dev/ttyUSB0, etc. in drop-down menus for port selection. If I add YAAC as a member of the group owning the 'serial port device' /dev/ttyUSB0 - or whatever it turns out to

That's because USB isn't a type of TNC or remote sensor. You could have your Argent Data Tracker connected through a motherboard COM port (non-USB) if your computer was old enough to have one; the TNC

No. When you install the Argent Data Tracker the Serial Port is no longer accessible. YAAC can't communicate with a USB port?

Alinco has a serial port, no? -------------------- From: "DavidC KD4E" <qrv@...> Reply-To: <[email protected]> To: <[email protected]> Sent: April 18, 2024 at 7:57 AM EDT Subject:

Can YAAC talk to USB? I looked in File -> Configure -> Expert Mode -> Add Port but none of the drop-down options mention USB. My rig is an ALinco DR-135T MkIII with an internal Argent Data Tracker

It doesn't seem to matter the number of messages. I sent a bunch of test messages and so far it is still working. I restarted last Thursday. We'll see what happens this Thursday. It's only been a

I can't be certain, but I am guessing you are exceeding your open file quota by re-opening the same .wav file without ever closing it. As such, eventually YAAC would no longer be open the file. This

After applying the latest update, I am now getting an alert as expected with an incoming message, however, it is not lasting. I participate in the APRS Thursday thing and when I send my report, I get

Hi Andrew, Ahh, that filters everything, not just the map. Didn’t realise that, thanks! Carl.

This is a trivially simple operation. Click Filter->Edit Filter. Then go to the Packet Source tab of the Edit Filter dialog, and uncheck all the sources you currently don't want to see. I put this