开云体育

A while ago, I was searching for a power supply that could provide enough current to TX full 10W and was less noisy. I got this excellent recommendation for an inexpensive switching power

The data flow for the spectrum is not enough for a full and high-quality zoom even for x4. I used a trick for this to somehow implement it. But this spectrum is partially "invented". If you do x8, it

It's safe. I'm going to update these values in the next release. Right now switching to USB-D on FT8/4 implemented in a different manner, and not always works as expected. But FT8/4 should also works

Hi Georgy, thanks for ALL Your Great Work I`ve noticed (using 0.23rc0) that changing bands in FT8/4 with upper arrow keys results in USB-D switching to USB. Clicking again buttons: APP - FT8/4

I want an extra AC charger for my x6100.? Does anyone have a source.? Appears to not have a listing on the Radioddity site.? An Amazon search brings up something that looks like it's for an

Use alternative firmware - then it is possible (;

So is there anyone who can provide tips for increasing the waterfall contrast?

the other thing I noticed this isn't the latest firmware in the video, it 1.1.7 app and 1.1.6 base, from over a year ago which basically only added wfview not the current

After watching the video , in my opinion the person had a problem with burning the image rather than with the image itself. He had a problem with Rufus , personally I didn't , he then? tried with

No problems here or with any other of the 5 users at my Local Radio club ! Sent: 11 September 2024 18:47 To: [email protected] Subject: Re: [xiegu-x6100] IMPORTANT! WITH LAST FIRMWARE THERE IS

Is this an isolated incident ?

Because FW 1.1.8 is so much bad and with many faulth’s ... after a lot of test’s and measurements... I changed back complete to FW 1.1.6 ( APP 1.1.7 & BASE 1.1.6 ). Otherwise I use only the

new? https://www.youtube.com/watch?v=C6sbH75b04A

hi please watch this https://youtu.be/_fj93Eqe60g?si=JSd_Rbol7c7Fba5 73 DE muhsin TA1MHS

... has til now nobody noticed that in App.1.1.8 in the audio scope the courser in CW is not on the PITCH frequency, but much too high, completely off the mark...!!?? The audio scope is absolutely

I agree with this. The gain is now as it should be - at 100% the gain is "100%" and anything less is attenuation... That is perfect behaviour and the RX is sensitive and lovely. Combined with the

I found a problem with the CW messages. Sometimes it would play incorrectly, missing elements and being generally undecipherable. Going out and back into message play at least temporarily fixed it.

It looks to me like power output is now being shown in the same field where received signal strength is shown when receiving.? When I key up it changes to a scale of 1 to 10 and the values shown are

My waterfall is lackluster and needs pumping up a notch or two. I’m guessing that altering either the receiver’s effective sensitivity (or other measurable real world receiving adjustment, e.g.

I don’t know why you all don’t realize that the firmware change notice said that the gain was changed. Yes previously, rfg of 63 resulted in a calibrated S-meter i.e. - 73dBm is S9. Now rfg of 100