开云体育

Hi guys Just something which may or not resonate with other users. Since running fldigi I always noticed that on running it there was never any received audio. Checking the soundcard settings on my

Hi list, has anybody encountered a similar little quirk: when I am receiving in MFSK 8 or 16, AFC being active, it does not function; instead it is necessary to manually adjust the two vertical lines

Hi list, has anybody encountered a similar little quirk: when I am receiving in MFSK 8 or 16, AFC being active, it does not function; instead it is necessary to manually adjust the two vertical lines

--- In win-fldigi@..., w1hkj <w1hkj@...> wrote: Hi Dave, thanks very much. Could you tell me how much is "within a few Hertz" to give me a guideline? Thank you 73 Fred DL6XAZ > > Hi

Hi list, when I go to "configure - modem - feld" and adjust the filter slider to say 150 Hz, then "save config - close " nothing happens because when then switching between any other mode and

Not for now Fred. The default bandwidth (for the internal DSP filtering) is always set to the optimal value for the pixel rate. Dave

Fully understood, Dave, and thanks for the quick reply. Since I am slowly going away from MixW, where a certain selected value could be selected and would be remembered, I was puzzled by the

Hi guys and dolls, Dave read the next link: http://www.hobby-hour.com/electronics/computer_microphone.php Hope it helps a little... Reg.: jan back in

Hello all. I have been using fldigi on an XP operating system with no problems. I recently upgraded to a new pc running Windows Vista Home Premium with a 64 bit operating system. I have installed

Hi Jim Have you tested out your Rigexpert on another data mode software ie like MixW ?. I remember reading somewhere about provlems with 64bit Vista drivers. Best Regards, Dave G3VFP . w1ret

Hello Dave, Do you mean problems with 64 bit Vista drivers for RigExpert? Thanks, Jim W1RET like drivers. problems. up. examaple it

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the win-fldigi group. File : /Installing Application on Microsoft Vista.pdf

Hi Jim Yes, but I can't remember where I saw the article. Certainly worth checking out with the agent for sure. I assume you have already tried using it with MixW on the same system. MixW version

Dave, Yes, I have sent off an email this evening asking about 64 bit drivers. I haven't reloaded mixw yet but I have tried it with DM780/HRD with the same results. I will try to load mixw and see

Using xp sp3. can't get cat working either using winlib (won't display freq or anything) or in rigcat (won't open html folder) I have modified the html rig folder and the 850 html folder for com6

Without knowing more specifics of your system I would not know how to advise you. Have you tried the Hamlib tab. There are some changes in the works for Fldigi with rig control that are still in

Thanks for the reply. Hp 2.4 mhz machine with 1 meg ram. Edgeport to convert serial to usb, ex sp3. G3??? cable from 13 pin port on 850 to edgeport for cat, rigblaster for audio. I have tried the

Hi Steve Forgive me if I missed anything, and am going over stuff of which you are already aware. Using Rigcat should work fine you take the ts850.xml file, edit it, and save it in your fldigi.files

Thanks to all. Special thanks to Dave. It is up and running now. Amazing decode!! Steve WB5OMP

Well thanks Steve. I'm sure Rich is as pleased as I am that you are up and running. It is an interesting software for sure. Best Regards, Dave