开云体育

I believe that early in my association with Willys Tech I read that a second row seat from a Dodge Durango would fit nicely. Can a member verify this I would appreciate it. Jim Ouimet

Thank you Don……I think I have the right one on the way….?

Look online at Kaiser Willys, Walck's, QTM etc and search by original part numbers. The leather seals have been replaced by new material but the part numbers remain? Don Wood

In my factory reprint service manual,on page M-5 for a dana 41 rear axle, parts #17& 18 appear (drive pinion leather oil seal gasket & leather oil seal,respectively). Are there any replacements for

Got it……definitely plugged……thanks for all your help!!???

My thoughts exactly

Richard, Forgot about that mounting plate. And it is a lot easier to do it all with the engine out. And, if, it's out, why not fix or get another crank,

?This might help . Don Wood 46CJ2A Sent?via?BlackBerry?10 ? Original Message ? From: willyswagon230 Sent: Tuesday, 19 July 2022 11:45 To: [email protected] Reply To:

Thank you!!!!!! That should get me there…..you guys are the best???

?This might help . Don Wood 46CJ2A Sent?via?BlackBerry?10 ? Original Message ? From: willyswagon230 Sent: Tuesday, 19 July 2022 11:45 To: [email protected] Reply To:

Dan Actually I referring to the fact that the flywheel mounting plate on the rear of the crank would make it impossible to install the sleeve. Unless there is something I’m not seeing here.

Richard, Good question. It would involve removing the transmission, bell housing, clutch, flywheel, oil pan, more. Then replacing the seal, reassembling with new clutch. Makes me tired just

Michael. Take a look at my Specifications page, go down to Rear Axle and you should see a picture showing the position of the breather hole on a Dana 44. This might not be the same position as your

Nice idea, but how would you get it on?

I hope this will open for you. If not, search, ?cj3a.info/tech/vent??

Have a pretty bad pinion yoke leak and will be changing the seal and need to also make sure my breather isn’t clogged…..that is,if I can find it!!! Any help is greatly appreciated……I THOUGHT I

I’ve used them on just about everything from crankshafts to wheel hubs to hydraulic pump shafts. They work great! Sent: July 18, 2022 12:49 PM To:

Never used it on the end of a crankshaft, but have used on several wheel bearing sleeve areas. Works perfectly. I cannot see why it would not work on the crank shaft. sF -- SF

Hi everyone, Been working on a couple of boat trailers, and problems with pitted and rusty spindles- in the area where the seal is supposed to keep out water- the inside- is a problem on one axle end

https://www.youtube.com/watch?v=5yVxEuMbftE [https://www.bing.com/th?id=OVF.3QvB0IxGz%2fRhkI9a23tpzw&pid=Api]<https://www.youtube.com/watch?v=5yVxEuMbftE> 4000 imported Japanese cars and 300+