开云体育

Hello Group, I'm in the investigation stage of relocating a repeater to a FM broadcast tower site.??? I've been on several LMR towers and not had any issues but wanted to see if there is any best

All, To let everyone know what I figured out (and aid others), there are TWO places you have to set the radio to full duplex if you have a wireline card installed, there's the settings on station

I've been curious about the Tektronix Nettek Y400 Portable Communications Test set showing up on eBay. The prices are attractive, but it looks like you have to be careful about what plug-in modules

Does anyone know of any school bus company or school district currently using SCHOOL RADIO, (Brand) PTT over Cellular mobile and portable radios? If so, please advise as I am looking for a good

That has been proven time and time again, although I have to admit I do have a combination scope/logic analyzer from HP that I find mostly-tolerable. We have a client that purchased two Tek

I have a Cell Master. I guess as an "all in one" kind of box that will do sweeps, and for occasional use as a spectrum analyzer it's OK at best. Other than a Field Fox, I don't know of any

bulletproof. I was talking about the differences in firmware/features only and how they were less important if using an external controller...but yeah, there were issues with the first-gen V1 PA's.

We had Y400s at work. They were in for repair a lot. I could have had one. I didn't want one. The Y400 reminded me of a Marconi 2955. It had a lot of clicking relays. I cannot speak on the

I had about a 10 minute chat with Bob at Henry Radio Wednesday afternoon. So here is what he had to say: 1. Henry Radio did not negotiate or in any way shape or form purchase T.P.L. Amplifiers. As

They both cover the frequency range I would be interested in. I guess the part I'm unsure of is that the Anritsu specifically says in the functions that it has a signal generator whereas the Tektronix

Putting a bow on the final installation by performing a sensitivity test with antenna vs a load and measuring any desense is very important. It doesn’t matter how well the repeater system works on a

My plan was to not id initially just to reduce the complexity even if only a small amount.

In my mind the question of "to ID or not to ID" is not really a big deal. Using an ID-O-Matic is not much more complicated than using a cross over cable.? My experience with an e-bay cross-over cable

Make sure the site test box has carrier wave TX down to the lowest frequency you plan or will ever think you will use. Later module boxes go father down. Not all site master type boxes measure

Bought an USB FTDI cable from BlueMax49ers.com, and was able to read the MTR-2000 from an XP machine.... now to program it and see what happens....

Does anyone have experience with both the Tektronix Y400 with YBA250 and YBT250 modules and the Anritsu Cell Master? I’m trying to decide on one for an entry level SA and VNA to use for radios,

MURS is simplex VHF low power only.. NO repeaters allowed Chris WB5ITT [email protected]> wrote:

Thanks Chuck.? I'll look into MURS. Jonny - I though I private messaged you but now can't find it.? I'll try again if I don't hear from you.

Check the transistors on the video board looking for cracked and broken leads or they could be cracked internally. ?Look at the solder connections on the boards also. if I remember it’s the A11

There’s no video adjustment option on the service monitor that I’m aware of. It’s just dumping the video processor board to the DB9 in a CGA RGB output. The newer models that have an LCD in them