Hello Group,
?
I'm in the investigation stage of relocating a repeater to a FM broadcast tower site.??? I've been on several LMR towers and not had any issues but wanted to see if there is any best practices I could learn from on what equipment should be mandatory for being on a FM broadcast tower site.??? I have listed what I have so far.? Any additional equipment please
?
1. The repeater will be on the UHF spectrum of the ham radio side.
2. It will be running a Kenwood NXR-1800K2 repeater with TXRX duplexers with a 100DB isolation between sides.
3.? Height will be between 350 to 400 ft
5. Cable is 1 5/8" hard line that was run but never used and capped off.
4. Antenna will be a commander technologies fiberglass antenna being side mounted on the tower with polyphaser lightening protection attached and grounded.
4a.? Jumpers will be 1/2 hardline between the antenna and 1 5/8" and the same going into the building.
5.? The radio station broadcast on 93.7 a with a ERP of 37,000 Watts and there antenna is at the 550ft mark.
6.? There only two 800Mhz commercial antenna's on the tower and a couple of Wifi provider dishes.?? I'll be above all of that equipment.
?
Thanks!
Steven H.
N8RLW
