开云体育

Sorry, this group.io thing here doesn't display Apple's picture file format.? So, I converted it to JPEG and reattaching it to show the voltage selector switch of my LA-1K (Serial Number: 38935,

Ron, Ok, so rather than using electricity provided by your local power company, you are powering your LA-1K with two (2) of your own generators -- main and backup units to achieve 242VAC and 239VAC,

I run my LA1K on a dedicated 240V circuit, and the voltage reading on the outlet is 242 Volts on Mains, and 239V when on backup generator.

Ron, In saying that you "run the amp from a 240V dedicated circuit" I am sure you have verified its output with a voltmeter. What's the VAC readout on your voltmeter for your 240V dedicated

Folks, It pays to read the entire thread … 1) in sumary, some units have a switch on the left side of the unit. This must be switched accordingly to whatever voltage you intend on running. And you

I received my amp from Palstar in Sept 2022 and it had a rather large warning flyer in the bag with the power cords (attached).? I didn't miss it and I run the amp from a 240V dedicated circuit.

Just Change to the 220 cord. Olen Persons 704-201-9446

Steve, When was your LA-1K delivered to you brand new? My LA-1K, purchased brand new directly from Palstar, was delivered to me on January 21, 2023.? My current home station configuration with the

I think I purchased my LA-1K in December.? It has the red switch on the on the left side, inside the hole in the case.? I toggled my switch numerous times to get the feel of it.? I have left it on

Hi Jim! Kidding about what?? If you are referring to the Palstar LA-1K not working...nope, not kidding.? After performing multiple tests with Palstar using over the phone testing, they now tell me

I have the auto switch power supply , but I would guess Palstar should probably placard the power cord and the side of the amplifier to prevent this kind of failure. Barry?

I replied, no I didn't. The RF detection worked well enough I left it alone. I run non-resonant antennas so I have to tune anyway, so I put the amp in standby, tune with 10-15W and then put the amp

Hey Chris, I sent you an email using your QRZ address on this. I am running the same setup and wanted to know if you got this working so that the LA-1K went to stand-by when you tuned using

Please tell me you are kidding? Jim KE4WY

I can assure you it is best to look for the switch!? I got one of the first to roll out with the new power supply. I had read the manual front to back several times while I awaited delivery.? When

I think we have isolated the problem.? Mark at Palstar just helped me run a number of tests on the LA-1K and he is convinced the linear is not working correctly.? We will ship it back to Palstar

Yes I did.

Did you go into the LA-1K menu and set it to use the data cable? There is a setting for that so if you removed the rca cable and didn't switch it to use the data cable it will not key the amp.

Quick update: I received the cable from Paul at Palstar and tested the amplifier.? It still does not work.? So now I am thinking it is either the the LA-1K, my new Yaesu FT DX-10, the Palstar HF

Yep, you’re correct there is no TX IN for the FTDX10. It’s actually TX Out (Pin 2 - Yellow) to Amp key In (Pin 7 - Yellow) on the LA-1K. In other words: FTDX10 output to LA-1K input. Only 6