Re: I need help making the cable that connects the Yaesu FT DX-10 to the Palstar LA-1K Amplifier
|
Yep, you’re correct there is no TX IN for the FTDX10.?
It’s actually TX Out (Pin 2 - Yellow) to Amp key In (Pin 7 - Yellow) on the LA-1K.?
In other words: FTDX10 output to LA-1K input.
Only 6 pins are used:
Blue wire from cable to Pin 1 of socket (Band data B)
Red wire from cable to Pin 2 of socket (Band data A)
Green wire from cable to Pin 6 of socket (Ground)
Yellow wire from cable to Pin 7 of socket (Amp key input)
Violet wire from cable to Pin 8 of socket (Band data D)
Blue wire from cable to Pin 9 of socket (Band data C)
Cable used: Yaesu SCU-28
Connector used: DB9 RS232 at: ?
I did continuity tests on the connections and used solder not the screw-downs to connect the wires.
This set up has worked perfectly with no problems at all.
Hope this helps
On Wed, Mar 22, 2023 at 9:27?PM David Campeau < davidc502@...> wrote: That's an awesome resource! I knew there was someone like yourself that
had already done the work, so thanks for sharing.
Best Regards,
David Campeau ki4dra
On 3/22/2023 5:52 PM, Bill K3HZP wrote:
> David,
> You are on the right track.? The info on my website might help clarify the differences of the two modes of operation.
>
>? ? ? ? ? ?73
> .... Bill K3HZP
>
>
>
>
>
>
|
