开云体育

I would like a hardware throttle (with a rheostat, and buttons) to control my SPROG test track. Ideally, it would be a simple device, maybe based on an Arduino, which would input commands to the JMRI

No joy here. Running W7, I have firmware 1.27 from the z21 monitor. I get nothing. Running version 4.6 throttles no good, but I could control points. Tim

Harold, I had a like problem but with some Digitrax decoders. I set up a fake consist on address 127 using some decoder numbers I will never use like 9999 and 9998. I leave them there all the time.

I get this error when I attempt to identify a new loco on my Lenz 100 system via wifi

You can upload your panel for the group to take a look at and see if we spot any errors. Something you can try in the mean time. Save the panel and reload it. Sometimes a restart is needed for the

I read the system requirements on JMRI site. I did not see anything about memory or processor speed. Are there any minimum requirements. My current machine is an old old Dell gaming computer I was

Mike, Our Elite support took quite a bit of work. Hor

Hi all, According to IOBit Malware Fighter JMRI contains a backdoor trojan in the following file "...\JMRI/\lib\x64\intelbth_x64.dll" on PC. JMRI version for PC 4.6-R81496dc Is this a

Thanks, Peter. Those changes looked good and were easy to pull into my copy. I've committed them to JMRI/EngineDriver. You'll want to update your repo from there (or refork) before adding other

Dave, Having read your advice in the link?NCE Consisting - Mark Gurries?I have the following question, which arises from a problem with consisting on my layout: ?As you say, when setting up advance

Paul, thanks again. I have re-posted the reply, as I see the colour I used in replies has been stripped! As for the memory being within the LH100, I agree that it has memory, but I don't think it is

Paul, thanks again. As for the memory being within the LH100, I agree that it has memory, but I don't think it is to hold the function and speed You are confusing two different things here, both of

Walt & Ken, The particular situation where JMRI “normalizes” the “user names” and maybe the “system names” does not prevent the panel from being loaded. There is a “WARN” message in

Mike, <jmriusers@...> wrote: You are confusing two different things here, both of which Lenz calls a stack. Lenz LH100 and Lenz LH90 have an address recall stack. This lets those throttles

Hi Bob, When you connect your phone to your desired network, is there an "exclamation point" on your wifi icon at the top? (your screenshot doesn't show the entire screen). If so, that exclamation

OK, so last night I tried again with the same results. I even went out to Staples and purchased a new router to see if that was the problem. It was not. Finally, I decided to try going through my home

ok, I have (hopefully) made one of the simple changes in a fork https://github.com/JMRI/EngineDriver/compare/master...flash62au:master

Possibly, but just a quick look showed that that folder structure is very different. It does not look like it would be simple to manually recreate the changes. Peter ---In jmriusers@...,

It is possible that if almost every single file is showing changes that your editor has changed the line endings on the file.

Hi Dave Thanks for taking a look at my problem. Rest assured that my signals files are all located where they should be in my own files area. The signals are in