开云体育

Dan, I'm not so sure Norman has a case of "a printer that doesn't quite work right with JMRI" so much as it might be that "JMRI (or Java?) doesn't work quite right with some printers". I opened a bug

Yes no matter how the xpressnet is connected (USB or xpressnet) you get the same functionality. POM and accessories (up to 256) also work. I'm still experimenting and don't use it as a main system

Art, if the phones have Wi-Fi you can use the Wi-Fi to install the app. I have a smart phone that is not activated as a phone but I can use Wi-Fi to connect to the internet using my router. Hope this

/On 6/22/2017 8:44 AM, yooper_from_49827@... [jmriusers] wrote:// / I have and they work fine. Most/all of those phones still have internet. Just park next to the coffee shop (or go have coffee)

Can you be more specific as to it's specs and the Dell model? Not only could we then tell you if it will run, if you want or need to upgrade it I could point you at the parts that will work for you.

The upper limit nog wireless throttles is likely the limit of the wireless router you're using......the router gives out IP addresses, and most are limited to 50 or so by default, but might be able to

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the jmriusers group. File : /Problem with Signal Logic on 37 Heaven/Updated

Background: We have a large O Scale club using NCE for our DCC. We have several people now who use their phone or tablet to run trains using the JMRI WiThrottle feature. Some use the Apple WiThrottle

Just to be clear. If you have NCE Power Pro system, and want to program Tsunami or any other decoder with CV numbers above 255 (Except ESU Loksound) you will need do one of the following: 1. Switch

Tim, I see two addresses being operated there, 837 and 2203, were those both being operated by Engine Driver? At the end of the log, the last operation request for each locomotive was properly

Ooops. Your question made me realize that I was having this conversation after apparently being misled by someone (maybe the engineers) into believing this is a problem. It appears now that I am

You will need to be more specific. What error are you getting? Paul

That is a difference in interpretation of the XPressNet protocol, and has been a long standing issue when mixing hardware from Lenz and Roco. We have always used the Lenz interpretation of the

Paul as requested. Tim XPressNet Tunnel Message: Mobile Decoder Operations Request: Set Address: 837 To Speed Step 70 and direction Forward In 128 speed step mode. XPressNet Tunnel Reply: EF C3 45 04

Trying out this nightly build version, I get a problem opening my panel. I'm using the Z21 for loco control and point control, plus MERG Cbus to control more points. Using the production version,

What you do internal to your node is separate from the protocol on the line. For example, you could keep the current status in memory, then compare it when something new is written over the line. That

Regarding car locations, I use Excel (older version, 2000) to import the car roster export. Before pre-building any trains for an Ops Session, I do this (Export) then create a spreadsheet with two

Ok, so the question we need to answer with that problem is where are we loosing the connection. It could be between the PC and the Z21, but it could also be between the PC and Engine Driver. One thing

Phil Is this the build report that works, or the one that fails? Dan

Sudden memory: Go to Preferences->Defaults and check that NCE is selected for everything, rather than Internal. -- Dave in Australia