开云体育

Jim K, You will be able to pick the interface from the Roster screen. It will have another select list, between the power buttons and the programming mode, that will pick which system you will use for

Same here Scott, Looks like Dave S. found the fix. Happily back running at 57,600. Thanks to all of the developers who support this great program. John Lang

Wow,? thanks Steve 009 - that sounds interesting and certainly worth a try....? I think I understand enough to give it a go! Steve G - My layout is continuous running - ie the same direction on any

Basic question Nick, how can I tell which editor I have used to draw the panels?

Thanks Dave problem solved Terry

/g/jmriusers/album?id=93593 i am finding this site difficult to get to grips with so your patience please with a newcomer. i have added a photo from my photographs into an Album. how

Billybob, That sounds like a better place than where I now am.? :) That is what I am going to do. I think all I will have to do then is edit the preferences to switch between PR-3 and LocoBuffer when

Re: Strange DP behavior? From:?forfoum@... Date: Sun, 28 Jul 2019 20:32:26 PDT? Since his setup is currently not working as is, I think dropping? it all in the same Profile will just add

Bob/Dave I have had similar issues that John Lang has experienced with setting the CMRI baud rate in "Preferences".? ?If I set the rate to anything over 19200, the effective rate was still 19200.?

Jim, It seems that you would benefit from having exactly one Roster, while being able to access it from any of several different profiles. Is that what you want to do? Regards, Billybob

Hi Tim, To test how JMRI copes I've created a panel xml file with 5000 x OpenLCB Lights, each with 3 FastClock Light Controllers. The hardware address increments on the final 2 byte pair on each side

Jim K, You could make a single profile that knows both the LocoBuffer and PR3. Then the different programmers will show a box to select which one you want to use at that time. You can fix up the

The pgm track is to a PR-3. The main is to a Locobuffer USB. I have a profile for the pgm track (COM5 PR-3), and a profile for pgm on the main (COM4 LocoBuffer USB).? I also have a profile for ops

Thomas, As this is my home layout, usually operated solo, ghosting should be a non-problem, or at least minor one. I'm hoping to have my EasyDCC connected to my new in the box Raspberry Pi 3B+, using

'Creeping Locomotives' may be a manifestation of some erroneous wording in early (circa 1997) NMRA DCC standards. IIRC, 'Emergency Stop' was described as 'the first speed step.' When the DCC working

Hi Folks I've done a project to throw 26 PECO turnouts with SG90 servos using Arduino Unos. A feature of this is to drive red/green LEDs with the Arduinos to show turnout position. No limit switches,

Hi Missed the title. If the throttle is being shared between a real digitrax throttle and JMRI, or is just a real throttle, if you E-stop it in JMRI the real throttle will just set the speed back to

All, A quick update on this - had some time this afternoon to implement the changes recommended by Geoff (namely, appending PT and ST to outputStream in the two scripts) and, after some work, I am

Hi Speed step 1 means Emergency Stop (i.e. Stop NOW and ignore deceleration settings). Which dcc system / command station are you using? Steve G. -- Sent from my Android device with K-9 Mail. Please

Terry, If you reply “No" and then save the panel, then the next time you load it, there should only be one. Attachments are removed from postings. On the group’s web page, images can be added to