开云体育

Jay, I assume the VB program provides the interface between the CMRI components and the physical CTC machine while implementing CTC logic. If so, take a look at

I had an issue with a USB to serial adapter dongle on my Mac with C/MRI devices.? It would send data to the SMINI's, and the SMINI would respond, both as indicated by LED activity, but JMRI

Hi all. I will need help I am sure.? Have downloaded and printed a large number of JMRI pages on the subject and will begin reading. The layout is basically finished.? It is O Scale.? Mostly a two

Did you remove the two jumper blocks on the WiFi shield? I had what seems to have been the same issue. As soon as I added the ESP8266 WiFi shield to my DCC-EX controller, I could not connect anymore

All, There is no question that JMRI code changes can torpedo any manual attempt to use a new definition without upgrading. As far as the include files are concerned, I would suggest that renaming

Bob, I am going to try the "One Only" turnout command option. Gopal

Dave, What was the macOS version before 14.7? After starting and getting the connection error go to "Help -> System Console". Use the "Copy to clipboard" button and paste in a reply. Dave Sand

Well, that didn't last very long. ?Just opened up JMRI and once again, back to the problem of JMRI not able to use the FTDI USB to serial adapter. ?I tried to boot into safe twice and it is still

I had Arduino and JRMI working with DCC-EX for several years.? But accidently fried the Arduino last week.? Bought new Arduino Mega, Arduino Motor Shield and Wifi shield.? ?Did auto install of

OK, I found out that the Signal Heads that I had added were interfering with the turnout logic. Only for first 3 turnouts were connected with the signal heads and hence they were showing inconsistent

Dave, I keep forgetting about Safe mode. Apparently there was some old data in a cache that needed to be removed. Dave Sand

Thanks.? I'll work on that this afternoon and evening.

Dave, This is somewhat embarrassing. ?I just started my iMac in safe mode, shut down and restarted. The FTDI interface appears to be working properly now with JMRI. Thanks for your assistance. ?I

Dave, I cannot find the option to "Allow accessories to connect" on my Intel Mac. ?It appears that option is used with Apple Silicon processors. I have installed FTDI 1.5.0 driver and restarted. I

All, I have updated the "Wait at startup" setting for the DCC++ Serial Connection in JMRI to default to "10 seconds" rather than "1.5 seconds". Existing connections are not changed. This will be in

Bob, Just an interim report to say that I followed your method and I could see 956 roster entries, none of which were my roster entries. I have a bad data set, which impedes immediate progress. I

Dispatcher supports signal heads with SSL, signal masts with SML or None. For signal heads with SSL, you must have direction sensors defined in the sections and added to the SSL. The easy way to

This is in a way a continuation of my previous thread "Programming Automated Trains", but it is a new question. I am trying to get my first train to run, but can't set it up.? It will run a train

Dave, I am running Sequoia but I have a dim memory of a USB issue. In Mac System Settings go to "Privacy & Security". Find "Allow accessories to connect". I use "Automatically When Unlocked". The

Dave, It says FTDI-FT232RL on the interface. FT232R USB UART: Product ID: ? ?0x6001 Vendor ID: ? ?0x0403 ?(Future Technology Devices International Limited) Version: ? ?6.00 Serial Number: ?