开云体育

I have panel pro working well with my NCE system via a serial cable to the five amp Pro Cab system. what I would like to happen is if a turnout gets thrown using an accessory command on the NCE

I did an upgrade from 4.24 to 5.3.5 including uninstalling J8 and installing J11 all from a thumb drive on a mate’s Windows 10 computer yesterday in about 10 minutes. It’s just not that

Steve, Here: Tom

Mel, I believe you have been using the Text Editor when previewing your Manifests and Switch Lists.? Take a look at the Manifest Print Options window below... This should allow to view your

MFRC522, Ethernet/Serial, Nano/Uno/Mega Steve, OK, so after much experimenting at home, it's simply the debugging messages being sent to the serial connection. I commented ALL of them out and now

Tom, This particular conflict can arise when the car with the custom load has no final destination.? When the program encounters a car with a custom load but no place in mind to send it, it will

Bob- I also just downloaded your fix and verified it works with my networked CMRI nodes.? I have been using a workaround for a while.? Appreciate the change. -Eric -- Eric Sitiko

Hi Pete, I've been digging, trying to find answers on my own these last couple days. I've been trying to print a switchlist using the Tabular, Two Column method like what is shown in this video

A spur can't receive a car with a custom load unless the spur also has a schedule, use the following help links for more

Hello, I have created a new custom load called E(HP) which purpose is to prioritize some empty cars over others.? However, I have tracks that won't accept a custom load according to the build report

Thomas, Just to confirm clearly, from what you've said, you've done everything right with the programming. JMRI and the loco's decoder have responded as exactly expected so there's nothing wrong with

John, As a general rule, signals (and NX sensors) are used to protect points of conflict. Those are usually turnouts and level crossings. As such, attaching signals and NX sensors to turnouts and

Unless there is an issue between 32bit and 64bit, I don’t understand either. If you can select Pi simulator you should be able to add GPIOs. Did you enable the GPIOs in the Raspian

I somewhat agree, however it is not as clear to me. I did read this several times before beginning, and I am a new user so there is a lot to take in. Statements like " It is not possible to add a

The image uses the 32 bit platform. I just thought that as I have a 64 bit board I should use it, it also allows the use of extended memory. The Jmri just refuses to select GPIO and states this error

John, Your link is for a different page. What you meant was https://www.jmri.org/help/en/html/tools/EntryExit.shtml The paragraph under the image covers the same concepts as your

Remember to also copy anything else you might need to the ThumbDrive too (like a new version of JAVA on the rare occasions one is needed) Might be a good idea to save (or "print to PDF") the release

Not a problem to upgrade offline. Just remember to *read* the release notes in case you need to take extra steps. In the past we have had JAVA updates, database reformatting, etc. These are listed in

Dave Thank you very much for your help. I now have it working they way it should including the LogixNG. I am not sure what your role is with JMRI but maybe your can help me with this proposal. In the

Hi group, I am struggling?with CS3 and DCC accessory decoders. I am using a CS3 (Central Station 3) which has the same Ethernet protocol as the CS2 (Central Station 2). I cannot get accessories to