Dave
Thank you very much for your help. I now have it working they way it should including the LogixNG. I am not sure what your role is with JMRI but maybe your can help me with this proposal.
In the??web page there is a section on placing sensors. My suggestion is to add a few more sentences to make the documentation better.
I suggest including the 3rd paragraph shown below, to the Placing Sensors section:
Placing Sensors
Sensors, along with Signal Heads and Signal Masts, can be added at?Block Boundaries. Block boundaries can occur at?Anchor Points,?Turnouts,?Level Crossings?and?End Bumpers.?Edge Connectors?are always a block boundary.
Sensors are assigned to anchor points, end bumpers and edge connectors by right clicking on the small colored box that represents the point and select?Set Sensors.... For end bumpers there will be one choice to make. Anchor points and edge connectors provide two choices.
Each Sensor has a direction associated with it such as East (or North) or West (or South). A sensor pair must consist of an Entry point and Exit point with each sensor in the pair having the same direction. If for example a West sensor is paired with an East sensor unpredictable behavior will occur with the signals logix(NG) or scripts referencing the sensor pair.
Can you advise me on the best way to suggest this improvement to the JMRI developers?
Regards,
John
John Figie