开云体育

Tim, Basically a signal is used to "protect" a "block" from being entered by reason of some conflict, usually either a conflicting route alignment or occupancy by another train. A "block" is a

Steve, That link doesn't work. It points to your local harddrive. I assume you wanted the link below, but I'm not sure what on that page you are referring

Hi John, The program allows you to use the same physical track for several industries.? Use the "Pool" feature to do this. You would create a spur track for each of the industries that will use the

Jeremy, The Linux install was recently upgraded. See https://www.jmri.org/install/Linux.shtml I recommend you use the Linux text editor instead of LibreOffice Writer. Dave Sand

Hi Wouter, Ah, I understand you, yes I only have one Cab in the form of the handheld Powercab, that could explain things, thanks.? Kind regards?Duncan?

I am following the Guide for installation of JMRI on UBUNTU 22.04. It has all gone successfully, until the last step. I can run PanelPro and Decoder Pro from the command line but I would like to have

Wow thank you guys for the help, It is greatly appreciated. Truly. So I went and cleared everything I had in the roster, threw the loco on the programming track, and clicked "Identify", after moving

I’ve tried showing all cabs and it only does the current one on the handheld screen unfortunately. ?I am running window 11 on a laptop. ?I wonder if I’m missing anything else? -- Kind

If memory serves, EVERYTHING on the cab bus (with a cab ID) shows up. Pretty certain my NCE USB did Phil G

ScottIf you are using a loconet connection is the "Transponding Present" in advanced options set to yes as per item 13 here

Mark, Read this and look at the Tsunami section. It' slightly different from the standard for locking: https://hostlersinn.blogspot.com/2023/04/cv-15-and-16-locking-decoder.html

Hi John & Folks I believe one way to do it is to set up the team track with "phantom" numbers Team Track-1. Team Track-2. Team Track-3, for each industry The Set Out won't be "Ryan's Rebar", it

Hi Duncan, You are confusing loco cabs (the locos under your control) with NCE's concept of a cab, which is a controller connected via the cab bus to the command station, in your case just the power

I have opened issue #11982 in JMRI's source repository to cover this problem.

Then I wonder why all the "Read" buttons on the decoder page are grayed out. My JMRI is 5.3.3 on Windows 10 wiht Java 11.0.14. Anyone have an idea why that might be? Scott Walton

I found out right away that I couldn't think of individual items like blocks, signaling, detection, and power feed. They are all part of a system. Start out with turnout protection. Signals are

Tim, Since you plan to do signaling, I would recommend each turnout, or group of turnouts, has its own block. For example, a "group of turnouts" could be two turnouts acting as a 3-way turnout. Or

The location and size are the most recent values when PanelPro is stopped. If you want to use the "stored" values, go to "Preferences => Display" and enable "Use old location and size logic for

Dear testers, I have just downloaded the current test version of JMRI as you can see by the title. ?I have had a look to see what ‘Cabs’ are on my NCE Powercab handset and can only set the

Scott Using Roco I can read all / read sheet, but, I cannot read any indexed CV. Steve G.