Wow thank you guys for the help, It is greatly appreciated. Truly.
So I went and cleared everything I had in the roster, threw the loco on the programming track, and clicked "Identify", after moving backwards for a bit it a pop-up appeared and read "3007 was read from the decoder but has not been found in the roster" and that was it.
After that I clicked "New Loco" and clicked "Read type from decoder" I selected one of the four highlighted Decoders, the "2 function decoder" and the long address read as "3007". On that same page I then clicked "Open Comprehensive Programmer". Once there I made the ID of the loco 3007, then went to the CV's tab and clicked "Read Full Sheet" and let the process complete. Here are the CV values:
CV 1: 3
CV 2: 10
CV 3: 1
CV 8: 101
CV 17: 203
CV 18: 191
CV 29: 38
The column next to the CV values on the right reads" read" on all CVs.
Also on the Comprehensive Programmer it says it has a primary address of 3, and extended address of 3007.
I don't know if that is the method you all meant when it was said to identify the loco not from the roster, but that is the method I took.
Thanks again, I truly appreciate it,
Thomas
