开云体育

I too have a ROCO locomotive and when programming with the decoder pro the response says it a Zimo decoder. However on trying to assign a number it does not allow any numbers. Using my Digitrax

Not so sure, it is detecting a Zimo decoder, but the numbers only go up to, I think, 649, and I have what the Roco website says is a NEM 651, so maybe I need to wait for the 651 to be programmed, now

This enhancement has been merged into 4.17.7, and will be in that release and 4.18 when it comes out.

Hello, My name is Craig and I am new to the user group. I love the JMRI program and have used it in the past at both home and a club I used to belong to. I recently moved and can't seem to get a

Hi Dave Great to hear from you again. Thanks for looking through and commenting on P2a12b. I shall put that right. Regarding Sensors, again your comment is correct. I changed strategy as can be seen

Peter, Turnout P1b has Inverted selected. I try to avoid using Inverted if at all possible. It is a potential issue I like to avoid. The P2a/P1b slip definition is messed up. The Turnout A/Turnout B

you are screwed as far as decoder pro is concerned most likely.

I take it then that this is a three rail AC locomotive with a Marklin Motorola format decoder? Sent: 08 December 2019 20:54 To: [email protected] Subject: [jmriusers] Roco locomotive / Motorola

Jan, All I am indicating is what dug up in the TCS decoder manuals regarding Hysteresis (or hysterasis)?? as it applies to the WOW decoder as I believe this is were the question came up from.? The

I have purchased a Roco Locomotive (Fleishmann) with a Motorola decoder, does not show up in list of decoders, am I out of luck or am I missing something? Robert J. Richter 283 Elm Street North

Hi I'm developing a fictitious layout in Layout Editor with twin track, with many twists and turns, such that it's difficult to follow which track is which. To help with this I've started using the

Files moved to: /g/jmriusers/files/ProblemsBeingWorkedOn/peter.s.drury -- Peter Ulvestad JMRI Users Group Moderator - http://www.jmri.org ( http://www.jmri.org ) Tam Valley Group

This is a place for temp files, other than administrative files. Either they are to be added to the next release, added to the Documents or will have a short life span. 开云体育 has free

I am having problems with two Double Slips - P2a/1b and P10/9. I have carried out checks on P10/9 it down to the Layout editor to map where the problem potentially lies and have narrowed the Layout

Hello, This email message is a notification to let you know that the following files have been uploaded to the Files area of the [email protected] group. * /Dale Junction version 081219/Dale

Hello, This email message is a notification to let you know that the following files have been uploaded to the Files area of the [email protected] group. * /Dale Junction 081219.xml (

Guys: There are issues where the sound volume resets on power up... read even a spot of dirty track... Check the instructions/drawings to be sure there isn't a pot buried in the locomotive to set the

The biggest hopp in programming MTH is having a Soundbooster card between your command station and the programming track?Also my experience with MTH is programming direct without the use of

F6 control volume on a Proto 3 ,you press and hold it till you get the volume you want and release it?Sent from my T-Mobile 4G LTE Device

Thanks guys! So for speed matching, I’ll set it to 0 and probably keep it at zero unless I consist it with other TCS equipped locos. Paul Sent via iPhone