开云体育

Uh Mark, where do you think Radio Shack got theirs? <g> Seth Neumann Mountain View, CA Sent from my iPhone, please excuse the typing.

Billybob, Nice bit of research. However, for any of the circuits I’ve seen for CTC panels, you always want break before make types. Next is ?” shaft vs 6mm shaft is less than a 1/64”

Dale, Here's my results from about 45 minutes work at the Mouser web site, looking only at "Alpha" rotary switches, and double-checking the part number versus the manufacturer's description. I

Can anyone help? JMRI runs OK on a Windows 10 PC. I can control throttles, turnouts and I have a working panel. Using Engine Driver on an Android 4.4 tablet, it connects OK to 192.168.2.2:12080 and I

Hello, I have an Athearn DDA40X non-sound unit that I purchased new. I didn't buy the sound version because I prefer the loksound select/direct decoders. My primary decoder is a Loksound Direct with

Great, thanks. I, too, bought a bunch of cheap Chinese ones and they wernt any better quality than the ones I got at the local Radio Shack when it closed. [jmriusers] wrote:

Mark, could you please provide the correct part numbers for the switches you referenced? You have shown the same part number for 3 different switches. Thanks, Dale Gloer

Andy, The CTCParts.com web site has an introduction to CTC - see http://www.ctcparts.com/about.htm http://www.ctcparts.com/about.htm . Specifically, "Part 5: The Control Machine", at the bottom of the

Hi all, any news on this topic, JMRI PanelPro - Programming Support for M?rklin CS2 / Doehler&Haass Programmer Regards, Moritz

Thanks Dan, regarding the Excel apps. James Allen jcallen1@...

Thanks for the recommendation. I'll check it out. Andy

Andy, Dr. Bruce Chubbs Volume 2 is pretty complete. His articles in Railroad Model Craftsman are helpful. Part 14 (April 2014) has a few photos. There are some references on line, but the only one I

Thank you Tony

Thanks for the information guys, much appreciated. Jerry Michels

Looks like Yahoo stripped off the photo. I've uploaded it to the files section of the group. There should be a file upload announcement with a link. Cheers, Dennis Drury Dayton, NV ---In

With the Mac you are simply dragging the distributed JMRI folder from the .dmg file to your Applications folder. Since you can't rename a folder on a disk image (Readonly) you'll have to rename the

Slow starting can happen for a number of reasons. What does the log say when it restarts? Does it still have the disconnected command station message? Alternately, if you open the XpressNet system

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the jmriusers group. File : /CTC Panel Cascade Sub.jpg Uploaded by : dennis95747

Hi Andy, I'm not sure if this group strips photos but here goes. The attached photo shows a prototype CTC machine that was on the Cascade line of the Southern Pacific. From top to bottom the switches

Where would I find a definition of the functions of the individual switches? I'm intrigued by the possibility of simulating a panel. Andy Reichert