开云体育

Thank you John

Ed, What you are describing does work. Make sure that the Layout Editor "Tools -> Check" menu items have no entries. Make sure that there are no warning or error messages in the system

There have been several DIY odometer cars on the net based upon bicycle computers, just have to make sure that the rolling stock wheel diameter is included in the computer's list of wheel sizes. A

Does anyone have any suggestions for measuring accurately through turnouts and curves to establish an accurate block length. I thought that possibly someone makes a rolling device that would do this

Gentlemen: I hope you'll be open to reconsidering this problem. I don't want to be a bother, but I think there is a problem with the programming required to make this capability function. I am

I was rereading the SB5 documentation and also you mention there seems to be 10 slots or cabs available: cab1 reserved for the system, cab 2 for the Procab, cab 3 for the USB adaptor Cab 4 -10 for

Mario, On the AIU it happens that the dip switch gets put in upside down and that on vs off is confused. Presuming the firmware was not the original, you can use 7-10 for the AIU board. First

Bonsoir Bernard comme tu parles de transit tu souhaites utiliser le dispatcher? Avec des trains auto? cela doit être faisable en mettant les deux trains en marche continue boucle et dans tes

Your issue with " occasionally servos move randomly without being activated" could also be from induced current in the servo wires.? I have had this happen when running DC, where the feeder wires

Cab2 is the Procab which shows the current locomotive assigned, cab3 is the USB adaptor, cab 4 when the little switches on the AIU are set to cab 4.? I do own another NCE cab04 handheld but not

Mario, What id is the USB set for and what other cabs are connected? Do you see all of those in the Show Cabs? You are likely on a current version due to when you had it repaired. -Ken

Ok I'll certainly check for that this afternoon when I get home.? I want to say its about 4-5 years old, I sent it to NCE for repair around 2 years ago. I'll follow up and thanks thus far Mario

Bonjour, j'ai une boucle avec une voie d'évitement, comme sur la photo. j'ai deux trains? (en bleu) je voudrais un mouvement continu, un train dans un sans, puis l'autre train dans l'autre

When you go to the CMD STA it should be the first thing it shows. It's in the form of a date. Related is how new or old is your SB5 ? -Ken Cameron, Member JMRI Dev Team www.jmri.org

My apologies for not suppling that info - SB5.? I don't recall ever seeing the firmware for the SB5 as does the Powercab / Procab.? Would the? SB5 firmware be displayed on the

Mario, Which NCE command station are you using? Which version of firmware is the command station using? Those matter in helping you get things fixed up. -Ken Cameron, Member JMRI Dev

Hi, this might be more of an NCE issue but I'm? trying to see the cab # displayed under 'Show Cabs'.? ?I'm having an issue with the AIU being displayed or even recognized by the NCE.? The board

John, I think this is the fix for the SML issue. There is a dummy block between NT837 and IT:NT831. This provides the block boundaries at the normal leg of each turnout for signal masts and NX

Hi John, Having done the discover, you need to store to make it "stick". If you did do that, forget I spoke, but make sure you open the updated version of the panel(s) and not simply the old one

John, It sounds like have an error either in the store process or the load process. Upload the messages.log file to the group's ProblemsBeingWorkedOn file folder. You might also upload the layout