开云体育

Hi, Can I use signal heads at turnouts to indicate closed/diverging paths, and use masts with SML, as long as I only key the heads to turnout positions, and use the masts for controlling block

Dave and Ken, Thanks for the replies... they help make a little more sense. But, of the 20 or so block boundaries I have on my panel, I am only able to "Set Signal Masts" on 2. ?I control-click (I'm

Have you made the main PanelPro window active by clicking on it? What are the first few entries in the menu bar starting with the Apple menu icon? Dave Sand

Hi Dave - thanks for the advice, but have not had any luck in getting this to work. Must be doing something wrong - maybe I'll give you a call if that's OK please? Peter

I have downloaded JMRI 4.16+R6 on an iMac with OS X Yosemite with Java 1.8.0.221 installed. ?The Panel Pro when opened does not show the options line showing File Edit Tools etc. Any suggestions as

Tony, I've always used the virtual mast for cases where I don't have hardware. I even use it while waiting for hardware. Then I can move to the real hardware later and define it right for the hardware

Tony, If there is no hardware, use the Virtual Mast driver. Dave Sand

Rummy, You don't have to put in all the fields for masts/heads. If you only need eastbound, then just input that mast. You must look careful at the popup to make sure you pick the 'Set Masts...'

Dear Dave Your note below. Would you use signal head controlled mast signal driver if the signal system is only on the layout editor panel but not implemented with real signal hardware Tony

Rummy, Signal heads and signal masts are two different signaling implementations. Signal heads use SSL (Simple Signal Logic) to control the head appearance. Signal masts use SML (Signal Mast Logic) to

It's not just the roster that you need to think about, but the common areas especially if you have block detection. You are going to have to use Logix or SML, so that a train from 1 gauge knows that a

So, I'm still struggling with signal masts. When I go to "Set Signal Heads" on a turnout, I have to put in names for 4 signal heads, 2 in each direction, even though traffic is in one direction only.

I have now had a reply from Mr. Deloof, which gives an explanation of the difficulties: [i]The programming track on the LocoCentral can at this moment only be used with the keyboard on the

Frank, Can you check the system console for error messages? Dan

Thanks Sam, Chris and Dennis Your suggestions regarding kernel have been helpful in keeping the train together.? Thanks again for your help.

Good to hear Jerry! Dave...

I am not so sure that switching to the LocoNet problem will solve your issue. Remember that you are using the same hardware and just adding an emulation layer on top of that. The command station takes

Gentlemen Success at last One of the cars was labeled as a Coil Car and should have been label in the car list as a Std Gondola, Made the change and everything fell into place. Thanks for the

Paul, The point is that all changes (of reports, arrays, ...) take place when the front wheels leave the block and nothing more seems to be changed - in the CAN messages(!), not so in the LocoNet

David I am? using both aggressive and very detailed.I have researched the missing car,but I will try again. There has got to be an answer. Jerry