开云体育

The 8th line in my System Console Message is a warning "2017-07-28 11:01:15,484 lenz.XNetInitializationManager WARN - Command Station disconnected, or powered down assuming LZ100/LZV100 V3.x [main]"

HI More thoughts on this problem. Two years back, when I started to define my own signal masts, I needed to have my own version of the signals in my user files folder to work from. I think now I must

Nom, Did you pick from the pull down for 'System Name' the 2nd connection?? It is correctly creating table entries for the two systems. What reason do you have for using 2 connections rather than

Just for completeness, one more possibility is to use an _internal_ SignalHead driven by the layout status, and then write a script that watches that SignalHead and sends the right commands to the

Steve, I don't think that it will be easy with existing JMRI signal head "type" definitions. The SE8c uses an odd encoding of two turnout addresses and both states of each turnout. It uses a "last

Ken thanks. I tried to create Sensors and Turnouts in both OpenLCB connections. Selecting "Make Sensor" or "Make Turnout" creates sensors or turnouts in the first connection only. Manually entering an

It is usually best to start a new thread with unrelated with unrelated questions because they can easily get lost. Now, as to your problem, there isn't anything JMRI is doing that would cause this,

Steve, This reply from Billybob explains a lot - why you were getting the funny flashing, why there was no check box for software flashing. And, why you were under the impression that CATS preferred

This appears to be a bug. We’ll get it fixed shortly (day or two). Sorry for the trouble. Bob

Layout Editor is really meant for telling JMRI about your _layout_. It’s intended to give you graphical ways to tell JMRI about turnouts, blocks, signals, etc. Panel Editor and Control Panel Editor

Ah ha yes I see, as that's what they are in fact. DOH! Thanks for that. John OD

Another option would be to add them to a layout as a single (RH or LH) crossover; they support two turnouts controlled via a single turnout control (circle) on the layout.

When you create (or edit) a layout (virtual) turnout you can assign a primary and secondary (physical) turnout to be thrown when that turnout is clicked. I've never tied it but you may be able to

-Ken Cameron, You are a savior! I knew it was something simple, and I was very frustrated when I wrote this post. Unfortunately, one individual took offense and i did not meant to insult the

Greetings all, The other day I had WiThrottle working fine on first attempt ever; today when I select "Start WiThrottle Server" the WiThrottle window opens and hangs with the message, "Advertising

Bob Z, I would say Bob B is the authority on the fascia displays. But my own use has been to consider the LE panel as part of the logic of things. I then create CPE panels to show things and allow

Firstly, thank you Bob J, Ken and Bob B. I now have the interlocking at CP Kiski working the way I think it should! But, of course, I have another question. Up until now, I've been working on the

Hi Dave I searched and searched for signalmasts-2.6.9.xsd but no instances of that file found. I then tried *6.xsd and found signalmasts-2-9-6.xsd so I guess I had been looking for the wrong file

I'm not new to DCC or JMRI but I am new to using PanelPro Layout Editor to control turnouts. I have the basics working end to end just fine, I can click on the screen and turnouts change so all good

Bob, Thanks for the explanation. Certainly explains why I was seeing the same string for 4.6 as well as 4.8. As I mentioned to Ken, I think I'll wait until I replace my laptop as this may be a driver