开云体育

Graham, To set the maximum speed for a particular section: 1) click on the Edit button in the transit table 2) when the sections for the transit are shown, press the "View/Add/Edit Action" button for

Thank you Roger

Glad you liked it. I've got a bit more footage to share when I get a Round Tuit! Thanks Kev for the info. Would be great to hear more detail of the methods used, are you planning on posting to the

Graham, I'm not an expert on this Dispatcher, but I think it is the signals that control speed.? Find a block that has a signal and set that block to slow to see if that works. Roger

Jon, ? ? ?Chrome should not be the problem.? I have Chrome and Windows 10.?? ? ? ?Is you computer set up for other users? Roger

Good morning Roger,?? I clicked run anyway and it started to install JMRI and gave me the folowing warning: Error opening file for writing: C:\Program Files (x86)\JMRI\LaunchJMRIexe. Click Abort to

Bob, The LocoBuffer-USB runs at 57.6Kb. I'm not sure where you might have seen 125,000. However as long as you have 'LocoBuffer-USB' selected in JMRI, then the baud rate is locked to the correct

Hi Roger I tried changing the speed in the block but nothing happened to the speed. ?Is it because Dispatcher is controlling the speed? Graham

The other possibility (which hardly ever happens by mistake, but you never know) is that you are using the simulator. That, too, makes all requests return 123. Absolutely forget about baudrate. This

Thanks to all.? I'll try turning off the verbal and see what happens. Ken

Yep, preferences are set. Wondering about potential baud rate differences. Near as I can tell LocoBuffer-USB is 125,000? (according to the doc). Yet DP has that blanked out in in references, What's

George, From the main PanelPro menu, select "Tools >> Tables >> any table”. From the table menu select "Store >> Store Configuration Only To File…”. This will write the table contents without

Hi Robert, Your MacBook Pro and WiThrottle devices should be logged into the same WiFi router so they can communicate.

Dave, Thanks for the pointer. Just what I needed. Installed and working. Marshall Sent: Thursday, July 12, 2018 11:09 PM To: [email protected] Subject: Re: [jmriusers] FTDI Drivers for a 50ft usb

Thank you Roger and for your help in the past. ?I have at last been able to set up a train in Dispatcher to go around a loop and stop in the station using internal sensors, logix and physical

I have JMRI 4.10 on a Windows Vista system. I have Loconet, RR Circuits, and all is working with the plan I have drawn, but some things are missing and I need to expand the layout to get them in

Graham, ? ? ?In the blocks tables there are setting for speeds.? Set the block you arriving at to Slow. Roger

Here's an illustration of what I'm trying to do... Below is a table I made of JMRI Throttle Speed settings that are mapped to the 126 speed steps. What I want to know is what JMRI Throttle speed value

The Function Key labels are not stored in the decoder so neither JMRI nor LokProgrammer can determine them. They are only stored in the ESU Sound File (or the derived ESU bulletin). -- Dave in

Thanks Klaus! I was thinking along these lines as my workaround. I'm messing about with speed tables and I want to make sure I can select each of the 28 entries in that table. I will try the scaling