开云体育

Lawrence, I have been using a LDG IT-100 Tuner with my IC-7000 without any issues for the past year. It couldn't be easier to setup and use. Daniel VE3NI (ex-VE6EDS)

I have the exact same setup and it works perfect, the IT-100 is made for the IC-7000!

I just moved and sold off my old gear beforehand. I really interested in getting an IC7000 and figured the LDG IT-100 tuner would be a good match for it (pun intended). I'll likely use it more as a

Apparently I must be getting out fine no matter what the power meter says. Just talked halfway across the country on PSK and the power meter dint move at all. I reckon I still have some learning to

OK maybe I'm not understanding the ALC adjustment and the power meter correctly. I can adjust the transmit level on the soundcard to the lowest setting in DM780 and I see just a hint of ALC on the ALC

But, specifically, does the ALC meter still indicate something more than zero when the power meter fades lower and lower? And is the reflected power the same with before and after it fades? Both will

ALC meter stays out of the red zone and when first comminicating in PSK the power meter will move to whatever setting I have it set at but it seems after it gets warm the power meter moves further

You are correct the one that switches between free and detent tuning is working properly. The other one may have a mechanical problem with the switch that is not disengaging the detent tuning. Randy -

Do you actually see the ALC kicking into action to reduce power output?

Have you check your Power supply,? and also the wire / fuse going to the Radio?? Wire size and lenght does plays an important part in transferring current from the source to the Radio. Do also check

I have used a similar setup with the IC-7000. All worked with HRD, DXLab & Fldigi. I recall lots of fiddling with software options to get things working. My current setup is RigControl via

Afternoon Guys, I bought two IC-7000s and could someone tell me what happens on the main tuning dial tension adjust. My two 7000 do not act the same . One of them always clicks no matter the position

I've been noticing mine doing the same thing when looking at the power meter doing PSK31. I'm starting to think it's a heat issue allthough the temp gauge never goes into the red, the case does get

I use fldigi with my 746pro and a CI-V and it does read the frequency and/or control the radio. If it works with other programs then you must have something set wrong in fldigi. Check if ou have

Do you have flrig installed? [Non-text portions of this message have been removed]

one thing to note: if you use the mini DIN port, you can not key with CI-V commands, you have to key via the PTT pin on the mini DIN port. If you use the CI-V keying commands it will put the radio in

More info for those interested, from the service manual. VER.NO. VERSION SYMBOL #02 Europe EUR #03 France FRA #04 Spain ESP #05 U.S.A. USA #08 Export EXP #10 United Kingdom UK Mark. From:

Hi everyone. I just purchased a new IC-7000 last month after many years of using a 706. The serial number on my unit is 2501XXX. Not sure if that means the country code has changed. It is a US version

I can control the transmit/receive function and sat tx rtty BUT it does NOT read the frequency – the rig is controlled by a simple interface via the CVI port and that port controls everything with

Maybe a bad/loose connection? Mine has the "TV" mod (for what it is worth ;) ) and sometimes when I exert moderate pressure on the bottom of the control panel, the display goes all goofy (i.e.,