开云体育

Hi, This has probably been asked before, but, what is a decent power supply to use at home with an FT 818. One that plugs into the wall :-) Thanks Tony

Hi you say you have output on VHF, How much power output do you have , Often only one of the finals go bad so you still have low output on VHF/UHF, So yes I think the final board is bad, Good

Greetings, Subject line says it all. I have output on vhf but no output on HF in any mode. Trying to remember if I read about someone else having the same trouble recently. Any input

THANK YOU!! Thanks to all who responded. Seems as though, YES, I can remote a rig from my apartment to my son's place.? Looks as though my 857 is the better choice between the 817 and 857. Now to

The remoterig solution, in case you don't know it, is kind of cool and simple. Think of the FT857 (I know, we're in the 817 group, but these radios are part of the same family). The FT857 has a

I am working with an sbitx V3, which has remote capabilities.. Maybe you can check that to see if it fits your needs.. 73, Dick

I haven't but I probably should. I've heart\d that latency can be an issue sometimes. 73, Charlie N1AOK <lecontejoe@...> wrote:

In slide 11 the pdf mentions remoterig boxes, that would sit between your FT-857 head in your new home and the FT-857 body at your son's home. CW may be able to be handled by the boxes, but AFAIK you

In our 80's, we are downsizing -- dramatically.? Will be moving from 2,500 sq ft house we built 17 years ago to 1,200 sq ft apartment. Our son lives about 10 miles away from the apartments on 5

Hello Group, I have decided to sell my FT-817ND and my Z11 LDG antenna tuner asking 425.00 u ship North America only. contact me via my E-mail at mikeymustang2000@... and leave a phone

Closing the loop and following up. I went the route of opening the base of the mic and running a wire from the cct board to the FL110 Pin 4. Simple job, works perfectly. The only thing i MUST remember

Hi everyone Some great? answers here that seem to have given me the info I need Yes its the RF sense switching thats causing the issue - I much would rather use a ptt sensing myself. As suggested ,

Jem, So it is best to use a PTT keying line ?so when you press the microphone, the FT817 is in TX mode with red LED on, and the FL110 is in TX mode with red LED on and then you speak which then

Hi Jem, please download service manual to adjust delay time and RF sensing sensitivity

Looking at the schematic could vr201 alter the hang time?

If the rx tx switch is relay activated it may be possible to alter the switch time by using a different capacitor depending on the circuit. I have a 70w amp for my 817 which has an electrolytic which

Hi Jem, As convenient as it might be to use RF sense for PTT I think it falls far short of satisfactory for SSB operation as you have clearly demonstrated. I reckon it would be much better to take

Jem, It sounds like you have VOX turned on.? It is found on the front panel menus.? Access by pressing the F key and use the select knob to move to menu 10 VOX.? Pressing the A key turns it on and

Hi I was wondering if anyone has any tip on this combo . it seems to work ok but as the 817 is so low power , the T/R switching on the amp keeps cutting in and out on ssb with the audio.. When Im at

Yep! Example, attached. This is an "AC Anywhere" 140w inverter, the kind you plug into your car's 12v Accessory outlet, driving a 60w incandescent bulb (a non-reactive load), but all the