开云体育

Built-in tuner? [email protected]> wrote:

I am on board with Zack. I have plenty of FT817s to use as IFs or TX drivers , or whatever. They are still great for a multitude of ham and non ham operations. Money is spent already. Its a known

I am not going to spend anywhere near that amount for a radio now. I have been perfectly happy with the FT817ND, mainly used as a 144 and 432 MHz IF rig for microwave transverters. There are a few

Here they have "reservation" at $35 but no price. https://www.dxengineering.com/parts/rsv-ftx-1f#overview I can't see how it's an FT817/FT817ND/FT818 replacement just because it's 6W on battery and

Some web sites selling it https://www.hamradiostore.co.uk/blog/introducing-the-yaesu-ftx-1f-a-new-era-in-portable-transceivers but not on shop yet

Yaesu web sites seem down. Maybe updating. $1,700 seems expensive.

Warning: Info stealing muskrat link.

MSRP US looks like $1,700 for QRP 'Field' radio, $2,400 for 100 watt 'Optima' radio w/amp. Brochure: https://x.com/VE6LK/status/1918109615260340710 Price list:

Or maybe contact the person you bought it from and ask them? 73….Eric VK2VE. Sent: Saturday, 26 April 2025 07:09 To: [email protected] Subject: Re: [ft817] Strane SMA on REAR. Without any additional

I mounted a small SMA on the rear of my FT817ND. It is used as the output of the IF (68,33 MHz) to watch as a spectrum display on an SDR module. I use the FUNCube dongle, as recommended. See photo.

Tomorrow I'll have to open to see what they did to this great radio! Today I have played with the 817 and SVXLINK and RIGCTL... My voice mail run well... It could be interesting configure the SVXLINK

Without any additional information we can only guess. It would be good if you could open the radio and see where the wire from the connector goes. The most likely explanation is to send an IF signal

Hi to all! I have a great FT817ND... bought used, replaced the internal battery and all run well. I replaced the "light" power connector with a coupler that provide two Anderson connector from

The BNC is too light for my huge hands... I prefer use the SO-239 on the rear. To avoid dangerous situations put a 50 Ohm or 75 Ohm impedance on the BNC.

All of the menu settings were correct. I took the filter out of the radio where everything seems to work OK and put that filter into the “problem” radio. It did not work. My assumption is that the

I use the Digirig with my 857D which is similar. You will find that the cables used from the Digirig to the radio are generic Ft-8XX I find they have a forum and often cover such questions. Try :

Sorry, I meant to type SSB on menu 38 Jerry Ki4ps

You have to select the filter on the 818 in menu 38. It gives you the option of cw or sub. Jerry Ki4ps

Have you enabled the filter in the 818 settings? It gives a choice between SSB and CW. I do not know the menu number, as I own the FT-817ND, not a FT-818ND. Hope this helps. Robert Watson ||

Hi Paul, Did you try putting the filter from the good radio into the other to see if it works in there or putting the new filter into the radio with the known good filter to see if it works there or