开云体育

I will

Let us know what was wrong with it, Dave

Thanks everyone. I'm just letting you know that I have decided to send the radio to a technician for possible repair. Again thank you all for your help. 73 Douglas Richards VE3FFR

"Christopher Maness" <christopher.maness@...> wrote: For the mod? -- Brian Morrison G8SEZ

This morning a list member in a collins group I'm a member of apologetically offered a Collins 500 KC CW for $299 - he said he knew the price was outrageous, but that's what they fetch. He was right,

Do you have a schematic? Thanks, Chris Maness -Sent from my iPhone

"Petr Ourednik" <indians@...> wrote: It's worth looking at the spec of the TCXO module, the TTS01NS part is intended to run from 3V but is 5V tolerant although with a significantly worse

What frq on RX And then by TX? Maybe split mode and second vfo out od ham band. 73 Alex OK4AS Dne pá 14. 10. 2022 1:52 u?ivatel Douglas Richards <ve3ffr@...> napsal:

SSB does not generate a carrier when the PTT is pressed.? You need audio to cause an actual signal to be generated.? Use CW and a key. Take care, Mark AA3K

Hi Douglas, The antenna port can be selected for each band individually. An ‘R’ will be on the screen next to the Frequency when the rear connector is selected. No R = Front (BNC)

You need to use FM on HF/6 as well to get a carrier to measure. 73….Eric VK2VE. Sent: Friday, 14 October 2022 09:26 To: ft817 <[email protected]> Subject: Re: [ft817] Output power On hf I was

Good Morning Petr, Yes the Internet is? very wide and deep If you do Find the Information Please Post, I Have tried different variations so far No Luck. So Far In All Of My Years of? FT-817's

TX error normanly shows up when out of band so check your freq, but there are other possiblities for the TX error. Mick SA4MDN

Ok, I just tested use CW. Display screen says TX err 73 Douglas

Try testing HF using CW and let us know.

According to the switch on the Rtsystems software, vhf and uhf are on the rear. Douglas

Sorry, but there is a BNC ANTENNA PORT on the front, mainly for UHF & VHF. So, NO ALL antennas are NOT on the back. Clyde KC7BJE

On hf I was using lsb, vhf/uhf, I was using fm. Douglas

Make sure you are using the correct antenna connector, front or rear.? Will have "R" on display if rear. The connector can be selected in menu for different bands. There is only one PA for all the

FT817 uses the same TX power train for all bands (unlike '857 and most other all-band radios) If you have zero power on some band it is very unlikely to be any of the transistors. Look at the block