开云体育

Shapr3d is great, and it's what I currently use (supports windows OS as well), but if someone is proficient in fusion360, they might find Shapr3d to be a bit lacking on features. You still get

I have never responded to one of these messages before so if it turns out weird i apologize. I tried Fusion360 Got a long way with it, but ultimately what changed my woodworking completely was

Thanks for the feedback guys. Imran, I’m curious if you are able to determine the appropriate high leg position from looking at the schematic and if so, how.

Hi Clinton, My T72 is year 2000 so the only electronics are the readouts. I’m not very familiar with the newer models. I would try what you are thinking but rotate the groover before you start it to

I have been getting up to speed on Fusion 360 and want to use it for four things: * Designing woodworking projects and making rendered images, drawings, and cut lists for them. * Designing woodworking

David, For full disclosure, I told Mike who I learned from ?. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Mike, good write-up. The table alignment sequence is visually covered in the following pictorial sequence. Each photo has a description. This is a Dual 51, but the process is identical for the AD941.

Thanks to Imran for getting me oriented on the alignment procedure. Remembering how hard it was to install the plastic end on the euro blade guard, I was hesitant to remove the shroud that ties the

As everyone has said (and probably you have discovered too) the "instruction manual" (really...just diagrams) is only mildly helpful. I actually am getting my AD941 commissioned on Wed, 7/5, so I

I can confirm the 2nd leg, I just completed the commissioning form for my saw shaper. Tolve construction

Hi Chris, I have an odd interest in Felder electrical schematics. The one you shared is very intriguing. I do not have exposure to older Felder schematics, so this one is new to me. More on this

Thanks Andy, I’m leaning that way too. Seems logical. How are you liking the machine? Thx, Wade

Thank you so much Imran and Brian! as soon as I get back to my shop, I am going to see about doing a set up and see if I can figure this out. On the beach right now soaking up the sun and grinding in

Thanks Brian! It’s beginning to make sense. Chris Rozycki

Imran, Thanks I would like to see that. Chris Rozycki

Hi Chris, Here are couple of images. I am using prolock caps so you should measure your cap. Measure protrusion on the underside of cap (illustration pic as I cannot hold caliper properly while taking

Thanks for that Rod. The Felder tech I spoke with yesterday told me that 99% of the time the manufactured leg will go to Line 2 on the machine (usually brown wire). I will try you method to verify. I

Set up is pretty simple on the shaper spindle. Use a pair of calipers and check the step on the cap, say it’s 8mm, then just make sure the space from the top ring down to the actual shaper spindle

Wade, I think the round bar was installed on my AD741 when it was delivered, that is why I cannot find the install instruction in the AD741 manual. Felder might have adjusted the round bar

Joe, This is what I was trying to caution against. In my situation, that I shared, the rings did not turn by hand check as you describe. Could be that my grip is not strong but I am rather fit. There