开云体育

Imran

Have you looked at McMaster carr?

I am restoring a BF 6-41 and the sliding table bearings need to be replaced. ?Any suggestions on were I can source them? ?The bearings are cylindrical (6x8mm). I have included a picture of the

Ok Joe thanks – I will try to contact them and see what they have thanks!! Sent: Monday, June 7, 2021 2:59 PM To: felderownersgroup@groups.io Subject: Re: [FOG] ProLock spindle locking mech

Michael, No luck on the drawing all my old emails are blank. Searching finds the ProLock emails but there is no content. Joe

Sounds good – hopefully we can get the drawing from joe and they can link back to what they made. Then we can see who all is interested - Sent: Monday, June 7, 2021 1:35 PM To:

Alex, Thanks for the details. Good to know that it is quiet and vibration free. There is a lot of metal around so likely heat won’t be an issue. Imran

I too would be interested in a ProLock for my 1 1/4” spindle. It sounds like this is a special order project. If a group purchase happens, just tell me where and when to send

Hi Imran, There is no vibration, and no rattle. There are no belts or pulleys. The compressor has four small rubber pads that were used to mount it to the original frame. I left those in place and

I have two 1 ?" spindles and would like two if we need a group order...joe Sent: Monday, June 7, 2021 8:01 AM To: felderownersgroup@groups.io Subject: Re: [FOG] ProLock spindle locking mech Thanks

Hi Alex, This is pretty cool but I would have never considered it because of vibration. A year or so ago, I placed my horizontal tank compressor under saw table. It is 2-stage belt driven setup.

Hi Mike, I didn’t want to run the big compressor just for Mac’s clamps. My solution was to purchase one of the little Senco brand compressors with a 1 gallon tank that the big box stores sell

Thanks - I did speak to them and the only had it for the 30mm spindle - Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Monday, June 7, 2021 12:15:37 PM To:

Felder resells them for certain machines and for either saw or shaper, just look up "quick-lock" on the e-shop: https://us.feldershop.com/index.php?lang=13&cl=search&searchparam=quick-lock I bought

Dave, ProLock makes them for saw arbors and shaper spindles. We are talking about the shaper spindle here. The spindle caps were 100 euro each, that must have been 2015 or 2017. Joe

Is this for shaper cutters or saw blades? If for shaper cutters what does it cost? Thanks, Dave Davies wrote:

Since this is a custom job, I thought I mention the other quick securing method is pneumatic. Anyone, knows if that requires a special spindle or can it be done with standard spindle? Imran

It allows you to change cutters without opening the saw and locking the shaft - hand tighten a nut and then a small set screw type mechanism and done Get Outlook for

What does it do? Dave Davies wrote:

That would be great - thanks joe!! Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Monday, June 7, 2021 11:06:38 AM To: felderownersgroup@groups.io