I too would be interested in a ProLock for my 1 1/4” spindle. ?It sounds like this is a special order project. ?If a group purchase happens, just tell me where and when to send $$.
toggle quoted message
Show quoted text
On Jun 7, 2021, at 10:23 AM, Joe Jensen <joe.jensen@...> wrote:
?
I have two 1 ?” spindles and would like two if we need a group order…joe
?
?
Thanks joe!! ?Was it a stock model - did you have to order anything special ? ? I don’t mind ordering 4 And seeing if others are interested?
Michal,
How was the class? ?I wish I was still woodworking just so I would have an excuse to go hang out with Ultimate Joe in Ouray, CO.
When I ordered the ProLock 1 1/4” spindle caps we had to order 4 to make a minimum custom order.
I ordered them directly from ProLock and picked them up at LIGNA that year.?
?
?
Hey Folks – I had seen a thread about the ProLock spindle locks and know that Joe D had ordered his for a 1 ?” shaper spindle.? I have a K700Z and saw these recently at the Rangate joinery class and was hoping to get one.?? Can anyone direct
me to a source?? I did try to see if I could message Joe but could not figure out how to do that on the forum -?
?
