Thanks joe!!? Was it a stock model - did you have to order anything special ? ? I don’t mind ordering 4 And seeing if others are interested?

Get

---

From: [email protected] <[email protected]> on behalf of bacchus6015 via <joeinno=[email protected]>
Sent: Monday, June 7, 2021 10:54:14 AM
To: [email protected] <[email protected]>
Subject: Re: [FOG] ProLock spindle locking mech

?

Michal,

How was the class?? I wish I was still woodworking just so I would have an excuse to go hang out with Ultimate Joe in Ouray, CO.

When I ordered the ProLock 1 1/4” spindle caps we had to order 4 to make a minimum custom order.

I ordered them directly from ProLock and picked them up at LIGNA that year.?

Joe

On Jun 7, 2021, at 6:41 AM, Michael Marsico <michael.marsico1@...> wrote:

Hey Folks – I had seen a thread about the ProLock spindle locks and know that Joe D had ordered his for a 1 ?” shaper spindle.? I have a K700Z and saw these recently at the Rangate joinery class and was hoping to get one.?? Can anyone direct me to a source?? I did try to see if I could message Joe but could not figure out how to do that on the forum -?

?

Thanks

?

Michael

?

704-783-7154

?